User manual PANASONIC CY-VMX6800U

[. . . ] E N G L I S H 1 Components To check the remaining battery strength: The POWER indicator on the right hand earpiece (R) dims or fails to light when the batteries are weak. Change the batteries if any of these occur. Display unit (1) Infrared wireless stereo headphones (2) Batteries (R03/LR03, AAA, UM-4) for wireless headphones (4) Installation hardware (screws, cords, etc. ) ( page 26) Power connector (1) Caution: Improper use of batteries may cause overheating, an explosion or ignition, resulting in injury or a fire. (There is the danger of liquid leakage. ) Do not disassemble or short the battery. [. . . ] Any attempt to install this product in a motor car by anyone other than a qualified installer could cause damage to the electrical system and could result in serious personal injury or death. Overview This product should be installed by a professional. (Please refer to the "WARNING" statement above. ) Identify and label the car wires. Connect the car wires to the wires of the power connector. If you encounter problems, please consult your nearest professional installer. Caution: This unit operates with a 12 V DC negative ground auto battery system only. Do not attempt to use it in any other system. Before you begin installation, look for the following items which are packed with your unit. Warranty Card. . . Fill this out promptly. Panasonic Servicenter List for Service Directory . . . Keep for future reference in case the unit needs servicing. Installation Hardware. . . Needed for monitor setting. Installation Hardware No. 1 Item Display unit Diagram Q'ty 1 2 Power connector 1 3 Binding-head screw* 6 4 Screw sheet* 4 Warning Do not install the monitor in a location which obstructs driving, visibility or which is prohibited by applicable laws and regulations. If the monitor is installed in a location which obstructs forward visibility or operation of the air bag or other safety equipment or which interferes with operation of the car, it may cause an accident. Never use bolts or nuts from the car's safety devices for installation. If bolts or nuts from the wheel, brakes or other safety devices are used for installation of the monitor, it may cause an accident. If the wiring is not correctly performed, it may cause a fire or an accident. In particular, be sure to run and secure the lead wire so that it does not get tangled with a screw or the moving portion of a seat rail. If the bulb also turns off and on, that outlet is the car power lead. If your car is not wired for an audio unit: Go to the fuse block and find the fuse port for accessory (ACC), or ignition (IGN). 26 CY-VMX6800U CY-VMX6800U 27 E N G L I S H 13 Installation Guide (continued) Connect All Leads Now that you have identified all the wires in the car, you're ready to begin connecting them to the controller unit wires. The wiring diagram ( page 29) shows the proper connections and color coding of the leads. We strongly recommend that you test the unit before making a final installation. You can set the unit on the floor and make temporary connections to test the unit. Use electrical tape to cover all exposed wires. [. . . ] Is the path between the unit and headphones obstructed by something? Has the battery run down? 17 This is a characteristic of liquid crystal panels and is not a problem. There are red, blue and green spots on the screen. (The liquid crystal panel is built with very high precision technology and has at least 99. 99 % effective image pixels. [. . . ]