User manual PANASONIC CZ-CWEBC2

[. . . ] Operation Manual Centralized Control System CZ-CWEBC2 Web Interface Thank you for choosing the CZ-CWEBC2 Web Interface. Before using the system, be sure to read this manual carefully. In particular, be sure to read the "Important Safety Instructions" . After reading this manual, store it in a convenient place. Contents 1. [. . . ] The Web-related settings, such as site name, e-mail settings, and network settings, can be made. Click on a box for an item you wish to set and directly enter values. [WEB settings] Enter a site name (within 40 characters). An "=" (equal sign) cannot be used. An automatic updating interval of a screen that will be displayed on the Web browser can be set. You can select from among Invalid, 10 seconds, 20 seconds, 30 seconds, 1 minute, 2 minutes, 10 minutes, 30 minutes, and 1 hour. If "Invalid" is selected, the data on a screen will not be updated until you click on the "New" button. * The following screens will be automatically updated: Each tenant ( ) Each tenant details ( ) All units ( ) [Network setting] When a DHCP instead of a static IP is used, select the "DHCP Enabled" radio button. If "DHCP Enabled" is selected, items ­ will be disabled. The factory default is "DHCP invalid" . Enter the IP address for the Web Interface. Refer to the settings of other devices, such as the PC and router. The factory default is "192. 168. 1. 1" . Enter the subnet mask for the Web Interface. Refer to the settings of other devices, such as the PC and router. Enter the IP address of the default gateway that is connected with the Web Interface, as required. 28 8 Initial Settings Main 33 Sub Enter the IP addresses for the primary and secondary DNS servers, as required. Enter the IP addresses for the primary and secondary WINS servers, as required. Enter a device name (ID name) of the Web Interface. (This device name is used for identifying the Web Interface when a DNS server is used. ) Up to 15 characters, "-" (hyphen), and "_" (underscore) can be used. Only an alphabetic (A­Z, a­z) can be used for the first character. Neither a "-" (hyphen) nor an "_" (underscore) can be used for the last character. [E-mail setting] The settings for automatic delivery of e-mail notifying of an occurrence of or restoration from an error of an air conditioner: For sending test mail Enter the IP address (or domain name) of the mail (SMTP) server that is separately contracted. One-byte alphanumerics, "@" (at sign), " " (bullet), "_" (underscore), and ":" (colon) can be used. [. . . ] When local remote control operation is prohibited on the Web Interface, start/ stop operation of air conditioners is disabled because of failure in the Web Interface. After the recovery from a power outage, the equipment did not come on automatically according to program timer settings. (*) When timer operation is set to "Set" or "Cancel" the timer operation indication on the remote , controller screen will be as shown below. Each time you click on "TIMER" the setting will change from , "Set" to "Cancel" or vice versa. When timer is set to "Set" When timer is set to "Cancel" 48 11 Troubleshooting · When the Internet is used for connection of the Web Interface to the PC, take security measures, such as installing an optional firewall. · The warning messages to be displayed during Web operations, their causes, and corrective measures are shown in the table below. Warning message Meaning and cause Corrective measures While the Web Interface is undergoing the following processes, Web operations are not possible: · During startup (after turning the Web Interface on) · During system configuration The access from the Web check is busy. [. . . ]