User manual PANASONIC CZRWST3

[. . . ] Important Safety Instructions Before using the system, be sure to read these “Important Safety Instructions”. After reading this manual, save it in a convenient place. €¢ Contact your dealer before moving the system Contact your dealer or a professional service provider about moving and reinstalling the system. Electric shock or fire may result if an inexperienced person performs any installation procedures incorrectly. [. . . ] Or / , and while the time is again, a scheduled time can The time last set on the timer is displayed. €œ--:--“ indicates time to change the batteries. / of the or and set the timer to the Every time you press , the time changes in 10 minute increments. / If you press and hold the button, the time changes quickly. After setting the timer, if you press , the time you set changes to a steady display, indicating settings are complete. After the timer setting is displayed for three seconds, the display reverts to the current time. Checking the timer setting • If you press either / for the or the , the scheduled time is displayed for four seconds. • When no timer setting has been made , it displays --:--. (Initial Setting) Changing a timer setting • Press / for the for the timer again. Or the , and then when the timer setting is displayed, press / Canceling a timer setting • If you press [CANCEL], the timer setting is canceled. €¢ If you wish to cancel the setting for either the or the timer, press timer and when the scheduled time is displayed, press [CANCEL]. / or the desired Using the same timer setting every day • If you press for 2 or more seconds, “ ” is displayed and the ON timer or the OFF timer will operate the unit at the same time every day. €¢ If you press fagain for two seconds or more, “ ” goes off and the timer operates just once. Adjusting the Wind Direction • Never try to manually move the flap (up-down wind direction plate) that is operated by the remote control. €¢ When the unit stops, the flap (up-down wind direction plate) automatically faces downwards. €¢ When the unit is in heating standby, the flap (up-down wind direction plate) faces upward. Also, bear in mind that the flap starts swinging after the heating standby mode is released, but the display on the remote control indicates Auto Flap during standby heating as well. CZ-RWSU2/CZ-RWST2/CZ-RWSL2/CZ-RWSY2/ Indoor Unit (CZ-RWSK2)/CZ-RWST3 Setting the Wind Direction While the unit is operating, every time you press direction the flap faces changes. , the In the Heat Mode Please face the flap (up-down wind direction plate) downwards. If it faces upwards, the warm air will not reach the floor level. In the Cool and Dry Modes Please face the flap (up-down wind direction plate) upwards. If the plate faces downwards, condensation may form and drip from around the air outlet. [. . . ] While holding down the buttons below, every time Whatever is being displayed when you release Setting Item Operation Button How to Operate is pressed the remote control’s display changes. Setting Content Heat Pump (with Auto) Press while pressing Dedicated air conditioner Heat Pump (without Auto) Remote Control Display Remote control operation mode display setting when is pressed EN Press Clock display setting while pressing AM/PM 24 Hour Max possible temperature setting in the Heat mode Press while pressing Maximum heating temperature range is 26 °C – 30 °C EN-19 OI_072023_all. indb EN-19 2014/12/19 10:24:19 14. Before Requesting Service Before requesting service, please check the followings. [. . . ]