User manual PANASONIC DMR-E55EB

[. . . ] (Excluding public holidays) Or go on line through our Internet Accessory ordering application at www. panasonic. co. uk Most major credit and debit cards accepted. All enquiries transactions and distribution facilities are provided directly by Panasonic UK Ltd. Also available through our Internet is direct shopping for a wide range of finished products, take a browse on our website for further details. Accessories 1 Remote control (EUR7720KB0) 1 AC mains lead (RJA0044-3C) Please check and identify the supplied accessories. [. . . ] However, when using this connection, picture received from a satellite receiver may not be clear, therefore we do not recommend it. RQCA1205 -1- EB EBL STEP 1 Connection Connecting a television with 21-pin Scart terminal and Satellite receiver When there is no 21-pin Scart terminal on the television (page 3) Change the "AV2 Input" setting to match the output from a satellite receiver and set the "AV2 Connection" setting to "Normal" in the SETUP menu ( page 41 of Operating Instructions) after tuning is completed (page 5, 6). indicates included accessories. indicates accessories not included. 1 4 are required connections. Connect in the numbered order. BE SURE TO READ THE CAUTION FOR THE AC MAINS LEAD ON PAGE 2 IN THE OPERATING INSTRUCTIONS BEFORE CONNECTION. To household mains socket (AC 220­240 V, 50 Hz) AV IN VHF/UHF RF IN Television's rear panel AC mains lead Connect only after all other connections are complete. Fully wired 21-pin Scart lead RF coaxial lead To the aerial 1 2 Y RF IN 4 Cooling fan 3 Aerial lead PB R - AUDIO - L OPTICAL VIDEO S-VIDEO AV1 (TV) OUT PR AV4 IN AV2 (DECODER/EXT) AC IN DIGITAL AUDIO OUT (PCM/BITSTREAM) R - AUDIO - L VIDEO S-VIDEO COMPONENT VIDEO OUT (NTSC:480P/480I, PAL:576P/576I) RF OUT This unit's rear panel AV1 terminal If your television is equipped with RGB input capability, by connecting with a fully wired 21-pin Scart lead you can see video using RGB output on this unit (below). To output in RGB select "RGB (without component)" from "AV1 Output" in the SETUP menu (page 41 of Operating Instructions). Fully wired 21-pin Scart lead DVD/VCR Satellite receiver's rear panel To view satellite programmes Press [INPUT SELECT] to select the input channel "A2" for the satellite receiver or put this unit in standby mode. To record programmes from satellite receiver using "Sky Personal Planner" function page 23 of Operating Instructions RGB This refers to the three primary colours of light, red (R), green (G), and blue (B) and also the method of producing video that uses them. By dividing the video signal into the three colours for transmission, noise is reduced for even higher quality images. To record programmes from satellite receiver by RGB signals page 23 of Operating Instructions -2- Connecting a television with AUDIO/VIDEO, S-VIDEO or COMPONENT VIDEO terminals and VCR Connecting to the television using the 21-pin Scart leads ( page 2) indicates included accessories. 1 indicates accessories not included. Connect in the numbered order. BE SURE TO READ THE CAUTION FOR THE AC MAINS LEAD ON PAGE 2 IN THE OPERATING INSTRUCTIONS BEFORE CONNECTION. To household mains socket (AC 220­240 V, 50 Hz) When making this connection, ensure you connect the audio cables to the corresponding audio input terminals on the television. To the aerial VHF/UHF RF IN AUDIO IN VIDEO IN R L S-VIDEO IN COMPONENT VIDEO IN Television's rear panel Red White Yellow AC mains lead Connect only after all other connections are complete. Audio/Video cable Splitter S-Video cable RF coaxial lead Aerial lead 4 3 Video cable 2 Y RF IN 1 Red White Yellow R - AUDIO - L OPTICAL VIDEO S-VIDEO PB AV1 (TV) OUT PR AV4 IN AV2 (DECODER/EXT) AC IN DIGITAL AUDIO OUT (PCM/BITSTREAM) R - AUDIO - L VIDEO S-VIDEO COMPONENT VIDEO OUT (NTSC:480P/480I, PAL:576P/576I) RF OUT This unit's rear panel Red White Yellow Cooling fan Audio/Video cable S-VIDEO OUT terminal The S-VIDEO OUT terminal achieves a more vivid picture than the VIDEO OUT terminal. (Actual results depend on the television. ) Use a splitter if you also want to connect the aerial to your VCR. COMPONENT VIDEO OUT terminal These terminals can be used for either interlace or progressive output and provide a purer picture than the S-VIDEO OUT terminal (below). Connect to terminals of the same colour. Red White Yellow R L AUDIO OUT VIDEO OUT VCR's rear panel You can also connect with the AV2 terminal on this unit using the 21-pin Scart lead. VHF/UHF RF IN Component video output Component signal outputs the colour difference signals (PB/PR) and luminance signal signal (Y) separately in order to achieve high fidelity in reproducing colours. If the television is compatible with progressive output, a high quality picture can be output because this unit's component video output terminal outputs a progressive output signal (page 46 of Operating Instructions). For progressive output (page 14 of Operating Instructions) -3- [For[the[United]Kingdom]only[[ Connecting a television with RF socket only and Satellite receiver Connect in the numbered order. If you do not have a Satellite receiver, connect the aerial to the RF Input socket of this unit and skip step 3. indicates included accessories. [. . . ] Press [Í DVD] to turn the unit on. Auto-Setup starts. This takes about 5 minutes. Auto-Setup DIRECT TV REC 1 4 7 CANCEL 2 5 8 0 SKIP 3 CH Ch 1 6 VIDEO Plus+ Auto-Setup in progress, please wait. RETURN: to abort 9 RETURN INPUT SELECT MANUAL SKIP [For]the[United]Kingdom]only[ (When connecting to a television with RF socket only) Set the new RF output channel to TV (refer to the instructions for your TV). [. . . ]