User manual PANASONIC DMWMCTZ40PP

[. . . ] Modèle DMW-MCTZ40 DMW-MCTZ35 Please read these instructions carefully before using this product, and save this manual for future use. il est recommandé de lire attentivement ce manuel avant d’utiliser l’appareil et de le conserver pour consultation ultérieure. For USA and Puerto Rico assistance, please call: 1-800-211-PANA(7262) or, contact us via the web at: http://www. Please read these instructions carefully before using this product, and save this manual for future use. [. . . ] € When closing the Case, be careful that no foreign materials get caught between the O-ring and the O-ring groove. Even one strand of hair or one grain of sand can cause water leakage. 12 VQT4V81 (ENG) DMW-MCTZ35&40_PP&E-VQT4V81. Book 13 ページ ２０１３年１月７日　月曜日　午後２時７分 Attaching the Digital Camera Read the notes on page 15 before attaching the digital camera. Turn off the digital camera and remove the strap from it. 1 Push 2 up with your finger while sliding 1 to open the buckle. π  2 Attach the digital camera to the Case. 1 • Be careful not to catch the shading hood 1. € If the air temperature is high and the water temperature is low, condensation may appear inside the Case. to prevent condensation , insert silica gel (supplied) inside the Case in advance. To prevent the Case from becoming fogged up, insert the silica gel about 1 to 2 hours before using the Case. € Silica gel Digital Camera • When inserting the silica gel, bend it as shown in the illustration below and then insert it as far as possible. If you close the Case with the silica gel not fully inserted, the silica gel will get caught in the Oring causing water leakage. (Minus buoyancy) How to attach the weights If you use 1 weight, align the protruding part of the weight with the tripod receptacle on the marine case and then using a slotted screwdriver or similar, use the supplied weights attachment screw to attach to the tripod receptacle. If you use 2 weights, align the projecting part of the second weight with the indented part of the first weight so that the weights do not overlap and then attach them to the tripod receptacle. Taking Pictures ∫ Be sure to check the following before entering the water Check the following before diving. • Is there sufficient remaining battery power?€ Is there sufficient memory in the card?€ Is the O-ring fitted evenly into the O-ring groove?€ Have you checked that no water leaks into the Case? ∫ Taking pictures 1 2 Turn the camera on. Display the scene mode menu and then set [Underwater]. [. . . ] Although the lifespan of O-rings will depend on how well they are maintained, how often they are used and their storage conditions, we recommend replacing them every year even if you cannot see any scratches. of the O-ring will deteriorate , causing a water leak. ˆ About maintenance • Do not use the chemicals shown below for cleaning, rustproofing, defogging or repair. using them directly or indirectly (with a chemical spray etc. [. . . ]