User manual PANASONIC EB-G500

[. . . ] For more information contact your Service Provider. Symbols Used F Shows that you should press the following key(s). , Text- Shows that the display text will be flashing. Safety Information This equipment is intended for use when supplied with power from the built-in charger or Dual charger (EB-CR600) through the AC Adaptor (EB-CA600). Other usage will invalidate any approval given to this apparatus and may be dangerous. Switch off your cellular telephone when in an aircraft. [. . . ] With the word "Sender" displayed or a telephone number in quotation marks (" "), pressing D dials the telephone number or pressing A stores the telephone number in the Phonebook. When a message has been sent or edited it will be stored in the Send List. Create will create a new message and send or store it in the Send List. Review allows you to review how much of the message area is available. Receive Message List Topics Languages Auto Delete Lifetime Message Centre Report Protocol You can receive, display, edit and/or send short text messages, of up to 160 characters. Before you can send a message you must enter the Message Centre number into the Parameters. Your Service Provider will supply the Message Centre number. Parameters The Parameters are necessary for receiving or sending messages. Auto Delete will erase messages automatically. When "Received Read" is selected, a new message will overwrite the oldest read message. When "Received When new messages are received, the message Any" is selected, a new message will overwrite the oldest indicator (N) flashes and they are automatically stored in message even though it may not have been read. When all the messages Lifetime is the duration that your message is stored at the are read, the N disappears. If the message area is full Message Centre. Delivery attempts will be repeated until the N lights and a new message will be rejected. It is recommended that you memorise your security codes. If you forget them contact your dealer for the lock code or your Service Provider for PIN and PIN2. Phone Lock will prohibit normal operation of the telephone. Only emergency calls can be made and received calls answered. Once the Phone Lock is enabled the lock icon (O) is displayed. To restore normal operation, enter your lock code. When Call Divert is enabled the divert icon (t) is displayed. You can divert voice, fax and data calls using different circumstances and to different telephone numbers. 24 25 Call Bar is used to restrict certain outgoing and/or Network incoming calls. Call Bar is controlled by a security Password that is supplied by your Service Provider. When New Network Network updating or checking the Status of Call Bar the telephone Search Mode must be registered with a network. Different Call Bar Network List restrictions can be used for voice, fax and data calls. Any When not in your home country you may use a network combination of call restrictions can be set. [. . . ] Short battery life for an old battery pack. Cause Remedy Check that the Battery Pack is fully charged and correctly connected to the telephone. 30 31 Problem Cause Remedy To maintain maximum performance always use until the Low Battery Warning and then fully recharge the Battery Pack. To revive the Battery Pack use the telephone until the Low Battery Warning and then fully recharge three times. However, if the battery life is still short, the Battery Pack has eventually worn out. [. . . ]