User manual PANASONIC EB-G400Z

[. . . ] 28 Answering a Call, Adjusting Volume, Vibration Alert, Automatic Redial Glossary of Terms, Trouble Shooting, Important Error Messages Advanced Operation . 34 Concept of Operation, DTMF Tones, Notes . 35 Call Hold/Call Waiting Stored Numbers . 13 Note Pad, Recent Numbers, Phonebook, Fixed Dial, Service Numbers, Hot Key Telephone Numbers Alpha Entry . [. . . ] Your Service Provider will supply the Message Centre number. Parameters The Parameters are necessary for receiving or sending messages. Auto Delete will erase messages automatically. When "Rcvd (Received) Read" is selected, a new message will overwrite the oldest read message. When "Rcvd (Received) Any" is selected, a new message will When new messages are received, the message indicator (N) flashes and they are automatically stored in overwrite the oldest message even though it may not have been read. When all the messages Lifetime is the duration that your message is stored at the are read, the N disappears. If the message area is full Message Centre. Delivery attempts will be repeated until the N lights and a new message will be rejected. To receive new messages you will have to erase unwanted the message has been delivered or the Life Time expires. Received messages will be stored in the Receive List. Flashing "·" will indicate unread messages. Once the message is selected, you can read, delete, edit and The Message Centre is where messages are sent before they are forwarded on to their destination. The Message Centre number may be pre-programmed into your SIM or supplied by your Service Provider. If you forget them contact your dealer for the lock code or your Service Provider for PIN and PIN2. Phone Lock will prohibit normal operation of the telephone. Only emergency calls can be made and received calls answered. Once the Phone Lock is enabled the lock icon (O) is displayed. To restore normal operation, enter your lock code. Network New Network Network Call Bar is used to restrict certain outgoing and/or Search Mode incoming calls. Call Bar is controlled by a security Network List Password that is supplied by your Service Provider. When updating or checking the Status of Call Bar the telephone When not in your home country you may use a network must be registered with a network. Different Call Bar that you do not directly subscribe to, this is called restrictions can be used for voice, fax and data calls. National Law may not permit roaming in your combination of call restrictions can be set. When the PIN is enabled you will be asked to enter the New Network is used to manually select a network that is PIN every time the telephone is switched on. If asked, available in your current location. [. . . ] However, if the battery life is still short, the Battery Pack has eventually worn out. Cause Remedy Check that the Battery Pack is fully charged and correctly connected to the telephone. The life of the battery pack is Short battery life for affected by improper charging, Ni-MH battery pack. this is inherent in all Ni-MH batteries. The telephone cannot be switched on when charging When the Battery Pack has been deeply discharged the Leave the telephone charging the Battery Pack for a few telephone will take a short time minutes before attempting to switch it on. to detect which type of Battery Pack it is charging 30 31 Problem Cause The telephone is locked. Remedy Unlock the telephone (Menu: Security: Phone Lock) Disable the outgoing call barring (Menu: Security: Call Bar) Calls cannot be made. Outgoing calls are barred. The telephone is not registered Move to a coverage area and operate your telephone after to a network. [. . . ]