User manual PANASONIC EH-366

[. . . ] above-average secretion by the sebaceous glands leads to oily skin. This over-activity is caused by hormonal changes, especially during puberty, inappropriate highfat or high-protein diet, excessive consumption of alcohol, etc. this over-production of sebum causes the pores to widen. Oily skin can have a shiny or dried appearance, depending on whether the flow of sebum into the pore has an oily consistency or has already dried within the follicle. [. . . ] Switch the appliance off and place it upright into the Charger with the switch facing toward the front. Around the tip and wings of the nose (Fig. Limit use of the Wide Cup over the whole nose to one minute or less. Limit use of the Point Cup to two minutes or less. (Do not repeatedly move over the wings of nostrils where the skin is thin. ) Use only the Point Cup if you have concerns about skin irritation. When mist is not released, follow the steps below to clean the appliance. Turn the Power Switch off and insert the pointed end (remove the cap) of the Cleaning Tool a (F ) into the Mist Nozzle for a few times. When both the Mist Switch and Power Switch are turned on, block the Mist Nozzle with the pointed end of the Cleaning Tool for approximately 10 seconds (while checking to see if the water in the tank is bubbling). - A cotton swab (F ) may be b used instead of the Cleaning Tool. If the mist is not released, repeat steps 1-4. â· Do not place or store the Charger near water. â· Never reach for Charger that has fallen into water. How to remove the built-in rechargeable battery before disposal of the pore cleanser (Fig. 10) The battery in this pore cleanser is not intended to be replaced by consumers. However, the battery may be replaced at an authorized service center. The procedure described below is intended only for removal of the rechargeable battery for the purpose of proper disposal. Always make sure that the battery have been removed from the pore cleanser before disposing of it. Unlatch the hooks on either side and pull out from the body of the appliance. Cut the red and black lead wires on either side and further pull out from the body of the appliance. Suction Hole (Filter) and Mist Nozzle Turn the Power Switch off and remove any accumulated dirt using the Cleaning Tool provided. â· Charger Clean the Charger using a cloth and soapy water, then dry thoroughly before resuming use. [. . . ] Do not use thinner, benzine, or any other solvents to clean the appliance. â· Do not charge the appliance where the temperature is below 0 degrees Celsius or above 40 degrees Celsius, or when exposed to direct sunlight, heat or excessive moisture. Dry the appliance completely before setting it in the Charger. A damaged or defective appliance should be returned to the customer service center or to an authorized customer service agent. [. . . ]