User manual PANASONIC EHHS99

[. . . ] (Household) Operating Instructions Hair Straightener Model No. EH-HS99 English 3 2 (Household) Operating Instructions Hair Straightener Model No. EH-HS99 Contents Safety precautions. . . . . . . . . . . . . . . . . . . . . 6 Parts identification. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 About the temperature control system. . . . [. . . ] --Doing so may cause the wire in the cord to break with the load, and may cause electric shock or fire due to a short circuit. --Doing so may cause electric shock or ignition. Do not touch the shaded areas when in use or right after use since they will be hot. --Doing so may cause burn. English Do not let the heated section touch the skin (ears, forehead, neckline, etc. ). Do not use the appliance with permanent wave liquids applied to your hair. --Doing so may cause hair or skin trouble. Do not use the appliance for any purpose other than the care of human hair. (Do not use on pets, etc. ) --Doing so may cause burn. 8 Do not use the appliance on the same section of hair for more than 2 times. --Doing so may cause burn or damage your hair. Disconnect the plug from the household outlet after use. --Failure to do so may cause electric shock or fire due to electrical leakage resulting from insulation deterioration. Hold the main body so the fingers do not touch the shaded areas during use. --Failure to do so may pinch the fingers and cause injury. Disconnect the plug by holding onto it instead of pulling on the cord. --Failure to do so may cause the wire in the cord to break, and may cause burn, electric shock, or fire due to a short circuit. Slide the appliance down entirely through of your hair without stopping. Only use the appliance on clean, dry and tangle-free hair. Recommended temperature for use depends on each hair type of condition. (see 13 page) --Failure to do so may cause burn or damage your hair. 9 English CAUTION ►Notes ●●Styling will hold for 1 day only. Hair will return to its normal condition after shampoo. ●●Effectiveness of nanoe™ and straightening may vary among individuals. Parts identification English A B C A Press Plate Tips B nanoe™ Outlet C Steam Inlet D Open/Close Lock E Cord F Plug G Iron Plate H nanoe™ Lamp I Temperature Setting Switch J Power Switch K Temperature Setting Lamp G D H I E F K J Accessory L Cleaning Brush (for the nanoe™ Outlet) About Open/Close lock Slide the Open/Close lock (shaded area) to lock and unlock. Locked Unlocked L ►Note ●●Do not try to force open when locked. This may damage the product. 10 About the temperature control system Standby mode If the temperature setting is on 230 °C, 200 °C, or 180 °C and the straightener is left unused for approximately 10 minutes, the temperature will automatically lower to 170 °C. [. . . ] When resuming use, press the [+] or [-] temperature setting switches and return the temperature setting to 230 °C, 200 °C, or 180 °C. Please request an inspection or repair from place of purchase. English It is on standby mode. All temperature setting lamps keep blinking. The time to reach operating temperature (approximately 100 °C) differs depending on the area. 100 - 120 V: about 30 seconds 220 - 240 V: about 30 seconds It takes time to reach operating temperature. If the problems still cannot be solved, contact the store where you purchased the unit or a service center authorized by Panasonic for repair. Specifications Power source Power consumption 100 - 120 V 50 - 60 Hz 220 - 240 V 50 - 60 Hz 38 W The amount of power consumption is determined as the arithmetic mean value of the power input occurring during a representative period. [. . . ]