User manual PANASONIC EP-1011

[. . . ] Always unplug the unit before cleaning. WARNING ­ To reduce the risk of burns, fire, electric shock, or injury to persons: 1. Always insert the power plug all the way into the outlet to reduce the risk of short-circuit and fire. The unit should never be left unattended when plugged in. Close and continuous supervision is necessary when the unit is used by people who are limited in their ability to move or communicate. [. . . ] · Avoid places where the unit will be exposed to direct sunlight for long periods of time or places where it will be exposed to high temperatures, such as in front of a heater, etc. , as this can cause discoloration or hardening of the synthetic leather. · Placing a mat or cloth under the unit is recommended to prevent floor damage. At Least 15. 7" (40 cm) At Least 15. 7" (40 cm) Mat 7 HOW TO MOVE THE UNIT CAUTION · Do not move the unit while someone is seated on it. · The legrest will start to move shortly after the backrest. Approx. 85° EXTENDING THE LEGREST LENGTH Legrest Slide Lever Pull back. Pull on the legrest slide lever and extend the legrest to desired length. (maximum approx. Release the legrest slide lever. · Extend legrest length by pushing legrest slide projection with heel. · Raise legs slightly and legrest returns. · Extend until the end of the legrest is lower than the knees to avoid discomfort. ADJUSTING FOR CORRECT PILLOW HEIGHT Adjust the pillow height so that the bottom edge of the pillow is at ear level. · If positioned too low, the pillow can lessen the effect of massage around the neck area. Fasteners 10 USING PRE-PROGRAMS AND QUICK MASSAGE 1. Press the OFF/ON button. 1 Press · The OFF/ON indicator will come on. · You can now select one of the pre-programs or one of the manual settings. 2. Select the pre-program you want. · Please press one of the flashing buttons. Too low · When the shoulder position indicator is flashing, adjust the position of the massage heads (upper heads) so that they lightly touch the shoulders. · The shoulder position can be adjusted up and down 4 in. · When it is not possible to correctly adjust the shoulder position, you may have to slide your body and adjust it again. · Persons whose height is less than 4. 6 ft. (185 cm) are recommended to use the chair in the manner described below when the massage heads do not touch their shoulders. When height is around 4. 6 ft. (140 cm) or less When height is around 6. 1 ft. (185 cm) or more Use by placing a cushion on the seat and sitting as far back as possible. Use by reclining the backrest and sliding your body downward. 12 5. Selecting an area for a focused massage · Please see pages 14­17 for details regarding manual operation. Massaging the Neck and Shoulders Massaging the Lower Back Press Press · Press this button to focus the massage on the neck and shoulders. (The upper and lower back will also be massaged slightly. ) · Press the button again to toggle it off. · Press this button to focus the program on the lower back. (The neck and shoulders will also be massaged slightly. ) · Press the button again to toggle it off. 6. Removing tapping from pre-programs Removing Tapping Action · Press this button to remove tapping in pre-programs. (The tapping will change to a kneading massage. ) * Press the button again to restore tapping to the program. Press 7. [. . . ] The legrest cannot be raised or lowered. H H H 22 Problem Reclining does not take place even though a massage is started in pre-programs. (The seat does not automatically recline. ) The backrest does not return to the upright position. Cause and Remedy H H In some cases the seat may not automatically recline depending on the position (angle) of the backrest or the legrest. (See Page 11) The backrest will not return to the upright position if the timer is activated or the button is pressed. (Pressing twice will return the backrest to its original position. ) (See Page 19) Switching can be hindered when the user's body weight is not resting on the massage heads. [. . . ]