User manual PANASONIC ER-160

[. . . ] 1 EN, ES (U. S. A. ) Printed in Japan Imprimé au Japon Before operating this unit, please read these instructions carefully. Caution · Do not place the trimmer in locations that are subject to high humidity. · Clean the body only with a soft cloth slightly dampened with water or soapy water. Never use a corrosive cleaner such as benzine or bleach. [. . . ] Never use a corrosive cleaner such as benzine or bleach. · Never immerse the trimmer in water or apply to wet hair. · The trimmer may become warm during operation. · Never tamper with the moving parts. · Do not disassemble the trimmer. Take it to a qualified serviceman when service or repair is required. Store the trimmer in a dry area, where it will be protected from damage. On the crown. Selecting the thickness of the finish Short finish (Finishing thickness of approximately 7mm) (Approx. 1/4") 7mm (1/4") Sc alp Long finish (Finishing thickness of approximately 9mm) (Approx. 3/8") 9mm (3/8") Sc alp approx. 9mm (3/8") Finish adjustment switch 13 14 Cutting procedure Fine trimming Trimming the sideburns Without any attachments Lower the thinning plate Raise the thinning plate Thinning the bangs Make sure the switch is facing upward and move the thinning plate down the hair as if combing. Apply the cutting blade Little by little comb the trimmer through the hair approximately 2-3cm (13/16-1 3/16") from the tip of the fringe while continuously checking the result. directly Cutting around the collar, the nape of the neck, and around the ears Make sure the switch is facing upward. The mechanism of the thinning plate The thinning plate will regulate the amount of hair reaching the blade, enabling the hair to be cut in small portions. Cuts only the hairs that enter these areas. Trimming around the collar, the nape of the neck, and around the ears Align the trimmer with the line leading down from the ear Apply the blade directly to the skin. Apply the blade directly Cutting the fine hairs on the back of the neck Turn the body upside down and cut against the direction the hair lays. Apply the blade directly to the skin. Body (back) 16 Hair Skin 15 Maintenance After use Turn the switch to [0]. Attaching the blade Removing the blade Make sure the Pop-up Trimmer is in the [Down] position. 1 Insert the blade Insert the hook B into the slot A . A B Press the blade 2 Apply slight pressure from the back of the trimmer against the blade. [. . . ] Apply the cutting blade Little by little comb the trimmer through the hair approximately 2-3cm (13/16-1 3/16") from the tip of the fringe while continuously checking the result. directly Cutting around the collar, the nape of the neck, and around the ears Make sure the switch is facing upward. The mechanism of the thinning plate The thinning plate will regulate the amount of hair reaching the blade, enabling the hair to be cut in small portions. Cuts only the hairs that enter these areas. Trimming around the collar, the nape of the neck, and around the ears Align the trimmer with the line leading down from the ear Apply the blade directly to the skin. Apply the blade directly Cutting the fine hairs on the back of the neck Turn the body upside down and cut against the direction the hair lays. Apply the blade directly to the skin. Body (back) 16 Hair Skin 15 Maintenance After use Turn the switch to [0]. Attaching the blade Removing the blade Make sure the Pop-up Trimmer is in the [Down] position. 1 Insert the blade Insert the hook B into the slot A . A B Press the blade 2 Apply slight pressure from the back of the trimmer against the blade. [. . . ]