User manual PANASONIC ER-230

[. . . ] 2) E Thinning Plate Lock Button Press and hold while sliding the Thinning plate D down to set the Thinning Plate back to its original position. F Dial Turn the dial to a higher setting to raise or lower the comb attachment G to the desired length (between 2 and 18mm). 4) Be sure to slide the Thinning plate down to "1" before attaching the attachment. Cleaning Lever Push this lever to remove bits of hair caught between the stationary blade and the moving blade. [. . . ] Blade Block Release to remove the blade block from the housing to clean or replace the blade. 9) Adapter Use this to connect the Trimmer to an AC power source for recharging or for AC operation. Oil Lubricate the space between the stationary and moving blade with 2 or 3 drops of oil after use. Rechargeable-battery operation Charge the battery by plugging the Trimmer into an AC source using the adapter. AC operation Plug the Trimmer into an AC power source using the adapter with the switch set to 0· cHARGE. Wait about 10 seconds, then switch the trimmer on. After use, return the switch to the 0· cHARGE position. Trimming of Beard Place the angled face of the comb against the skin and cut the beard by moving the trimmer in all directions to obtain a uniform cut. 5) With curly facial hair, the comb attachment may not cut all of the hair. In this case, remove the comb attachment and use a conventional comb to draw out the remaining uncut hair. ⷠDo not continue charging for more than 48 hours. Clean the housing only with a soft cloth slightly dampened with water or soapy water. The Trimmer may become warm during operation and normal recharging. Do not use the trimmer near or over basins filled with water. Take it to a qualified serviceman when service or repair is required. D o n o t a t t e m p t t o u s e a n y power cord or adapter other than one specifically designed for this model. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Information for Users on Collection and Disposal of Old Equipment and used Batteries These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste. For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points, in accordance with your national legislation and the Directives 2002/96/EC and 2006/66/EC. [. . . ] Information for Users on Collection and Disposal of Old Equipment and used Batteries These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste. For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points, in accordance with your national legislation and the Directives 2002/96/EC and 2006/66/EC. By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. For more information about collection and recycling of old products and batteries, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items. [. . . ]