User manual PANASONIC ES-7036

[. . . ] You can fully charge the shaver in 1 hour if the LED display shows "low" (low). 1) A Protective cap B System outer foil C System outer foil release buttons D Foil frame E Inner blades F Foil frame release buttons G LED display H Battery capacity monitor H-a high H-b mid H-c low I Charge status lamp J Low battery indicator The unit can be used once or twice more after the "low" (low) starts to blink. (Differs depending on the use situation. ) [for ES7036] The charge status lamp will glow when the shaver is being charged. [. . . ] Remove the inner blade one at a time by grasping it firmly at both ends and pulling straight away from the shaver. Do not touch the metal parts of inner blades. To insert the new inner blade, hold the blade one at a time at both ends and press downward until it snaps into the shaver. Put a thin layer of shaving foam on your face which works as a lubricator. Shaving foam is the most suitable among many other shaving aids (gel, soap, cream, etc. Do not put a thick layer of shaving foam as it may affect shaver's performance. If the shaving head is clogged with foam, simply rinse it under running water. Caution ­ The system outer foil is very thin and can be damaged if handled improperly. Before each use, always check the foil for damage. To avoid personal injury, do not use if the foil or other parts of the shaving head is damaged. Depress the switch lock button and slide the On/Off switch upward to turn the shaver on. Remove the inner blades one at a time by grasping it firmly at both ends and pulling it straight away from the shaver. Clean the outer foils, the shaver body and the trimmer with the long brush (see fig. Clean the inner blades with the short brush by moving it in the Place the trimmer at a right angle to your skin and move it downward to trim sideburns. Please make sure that the batteries are disposed of at an officially assigned location, if there is one in your country. How to remove the built-in rechargeable battery before disposal of the shaver (see fig. 11) WARNING: Do not attempt to replace the battery for the purpose of reusing the shaver. This could result in the risk of fire or electric shock. The battery in this shaver is not intended to be replaced by consumers. However, the battery may be replaced at an authorized service center. The procedure described below is intended only for removal of the rechargeable battery for the purpose of proper disposal. Disconnect the power cord from the shaver when removing the battery. [. . . ] For proper treatment, recovery and recycling, please take these products to designated collection points, where they will be accepted on a free of charge basis. Alternatively, in some countries you may be able to return your products to your local retailer upon the purchase of an equivalent new product. Disposing of this product correctly will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. Please contact your local authority for further details of your nearest designated collection point. [. . . ]