User manual PANASONIC ES-883

[. . . ] The symbol means that the hand-held part may be used in a bath or shower. Treat yourself to wet lather shaves for at least three weeks and notice the difference. Your Panasonic Wet/Dry shaver requires a little time to get used to because your skin and beard need about a month to adjust to any new shaving method. 1 Usingtheshaver Caution - The outer foil is very thin and can be damaged if not used correctly. Check that the foil is not damaged before using the shaver. [. . . ] · Charging is completed when the indicators on the LCD panel blink. 1 hour later) theshaver. · You can keep the shaver attached to the recharger, or connected to the adaptor, when not using it to maintain full battery capacity. 1 Chargingwithouttheself-cleaningrecharger You can also charge without the recharger. Insert the appliance plug into the shaver. Plug in the adaptor into a household outlet. 4 Sh av e AbouttheLCDpanel The LCD panel shows the remaining battery capacity from 0% to 100%, in 10% increments. While charging After charging is completed 10 minutes after charging is completed 90° The indicators glow. During use min. used The indicators blink once every second. The indicators blink once every 2 seconds. After use min. used 1 PresstheOFF/ON 2 Holdtheshaveras illustratedaboveand switch. shave. · Start out shaving by applying gentle pressure to your face. Stretch your skin with your free hand and move the shaver back and forth in the direction of your beard. You may gently increase the amount of pressure as your skin becomes accustomed to this shaver. Applying excessive pressure does not provide a closer shave. In this case, perform the course again from the beginning. · Do not detach the detergent cartridge or the water tank as the cleaning liquid may spill causing a malfunction. Coursecompletionsummary On shaver Time required (guide) [In the low DRY CHARGE temperature] Blinks 1 hour Blinks ­ Blinks ­ 2 hours [+30 min] 1 hour [+30 min] 2 h 40 min 1 h 40 min Courseselectionindications Course 1Charge 2Clean/Dry/ Charge 3Clean/Dry 4Dry/Charge 5Dry *The lamp goes out in 6 seconds. On recharger CLEAN DRY Changeable course CHARGE halfway through * 2345 3 2 235 234 Glows Glows while charging ­ Glows while charging ­ On shaver On recharger CLEAN 2 1 1 Inserttheappliance 3 Removethe 4 Press[SELECT]toselectthecourse. shaver. · Turn the shaver off before · Remove any soap or water on attaching. the shaver if it has been · Check that the outer foil is not washed with hand soap or deformed or damaged when any other detergent. you are attaching the shaver. 7 11 1 1 Cleaningwiththeself-cleaningrecharger(continued) 1Follow the steps outlined below if the status lamp blinks or glows during the "Clean/Dry/Charge" course or the "Clean/Dry" course. Blinks Correctly set the detergent cartridge and then restart a course. Ifthestatuslampgoes out Continue a course. Glows Remove the shaver from the selfcleaning recharger and then check that the [CLEAN] lamp has gone out. (Be careful as the blade may be hot or wet. ) Check that the water tank is correctly attached, the water tank cap is securely closed and the selfcleaning recharger is placed horizontally. [. . . ] Place your fingers on the finger rest while using the shaver. Lubrication To maintain shaving comfort for a long time, it is recommended that the oil provided with the shaver is used. Apply one drop of oil to each of the outer foils. Raise the trimmer and apply a drop of oil. [. . . ]