User manual PANASONIC ES-WD92

[. . . ] Before operating this unit, please read these instructions completely and save them for future use. With our WET/DRY technology, you can enjoy using your Panasonic epilator dry or in the shower or bath for gentle and easy epilation. Please read all instructions before use. Make sure skin is clean before and after use. [. . . ] The beginner cap narrows the epilating area thus reducing the number of hairs removed at one time. It provides a more gentle epilation for beginners and those with sensitive skin. â· We also recommend warming the skin to soften the skin before use. You cannot operate the appliance while charging. 1 hour The epilator can be used for approximately 0 minutes (0 minutes when using the beginner cap/gentle cap) after 1 hour of charging. You can shave hair leaving the length of 2- mm by using the bikini comb attached. We recommend that you shave to days before using the epilator. Using the bikini comb Place the bikini comb onto the shaver head and slide trimmer up. When the bikini comb is in place, make sure the comb is in close contact with the skin. Areas suitable for epilation The epilator can be used on the areas. Trim your hair before epilating for the first time or if you have not epilated for a long time. Hair removal is easier and less painful when the hair is short. Remove the head while holding the head release button. Cut your hair to between 2 mm and mm long. Cut your hair to between 1 mm and 2 mm long. Before epilating the bikini-line, be sure to put on your swimming costume or panties etc. Using the epilator on areas other than those marked may cause pain or skin trouble. â· In the case of dry epilation, spread out paper etc. Areas not suitable for epilation The epilator should not be used on the inner side of the upper arms and areas such as elbows or knees which are prone to sagging. Always use body soap when wet epilating. â· Rinse any body soap out of your hands. Foam makes the epilator slide better, so you can move it fast. [. . . ] Switch on the power, bring the foot care head into contact with the skin, and begin filing. Lift the frame, fast/ 1 gentle/beginner caps upward while holding the frame release rib [B3]/the cap release rib [CDE7] or remove the frame by pushing the frame release button [H]. Clean the epilation head [B, F] and the shaver head [H] with the cleaning brush [M]. Turn the switch on and then wet the discs and the blades to create foam. [. . . ]