User manual PANASONIC EUR511156

[. . . ] You may need to change the remote control code. [. . . ] Check the table for the brand and enter the code as follows. Code table RECEIVER AV SYSTEM ^ CD ^ TAPE -MONITOR DVD -ANALOG 6CH TV DVD RECORDER VCR Changing the codes TV TV VCR VCR DVD player DVD -ANALOG 6CH 1 4 7 DIRECT TUNING 2 5 8 0 = 3 CH 6 VOLUME Press and hold the button corresponding to the equipment 9 -/-- DISC >10 MUTING 1 4 7 2 5 8 0 3 6 9 Enter the first digit u/t y/i TUNER/BAND g h q TOP MENU e MENU DIRECT NAVIGATOR w ENTER PLAY LIST q DISPLAY RETURN r HQ SOUND MODE TV/AV 1 4 7 2 5 8 0 3 TV VOL ­ TV VOL + DVD RECORDER DVD/HDD 6 9 Enter the second digit HELP -TEST SUBWOOFER -SETUP CENTER FOCUS STEREO/ 2CH MIX OFF MULTI REAR % PL x ­ w LEVEL DTS NEO:6 + q EFFECT The remote control outputs the on/off signal. If the code is correct, the equipment turns on or off. If it doesn't, try entering another code. While pressing [ENTER], press and hold [8] or [9] for approximately 2 seconds. The factory setting is [9]. ^ TV AV SYSTEM 1 4 RECEIVER 2 5 8 0 = 3 CH Switch on the player or recorder and start play Switch off DVD player DVD recorder DVD -ANALOG 6CH DVD RECORDER AV SYSTEM 6 VOLUME ^ ^ ^ 7 DIRECT TUNING 9 -/-- When using a Panasonic DVD recorder MUTING DISC >10 Operating the DVD player/DVD recorder TOP MENU u/t y/i TUNER/BAND Change the unit's remote control code to match the remote control code of the DVD recorder. Preparations: Check the remote control code of the DVD recorder. [. . . ] For about one second hold down both [ENTER] and the button ([1], [2] or [3]) which the same number as the remote control code set by the DVD recorder. [. . . ]