User manual PANASONIC EW280

[. . . ] The device is not intended for use on infants and children. The device is designed for home use only, not for ambulatory measurement. Specification of this device including pulse rate (30 - 160 pulse/min. Blood pressure measurements determined with this device are equivalent to those obtained by a trained observer using the cuff/stethoscope auscultation method, within the limits prescribed by the American National Standard, Electronic or automated sphygmomanometers. [. . . ] Do not mix different types or sizes of batteries. Be sure to insert batteries with correct polarity, as instructed. Remove batteries when they are worn out, and dispose of them properly according to all applicable environmental regulations. Do not disassemble batteries or throw them into a fire. Do not attempt to recharge the batteries included with the unit. 5 Precautions to Ensure Safe, Reliable Operation 1. Do not insert foreign objects into any openings. If the unit has been stored at temperatures below 0°C, leave it in a warm place for about 15 minutes before using it. Otherwise, the cuff may not inflate properly. Do not store the unit in direct sunlight, high humidity or dust. Easily Check Your Blood Pressure Readings Against the JNC 7* Classification Blood Pressure Categories Diastolic Blood Pressure (DBP) Stage 2 Hypertension 100 90 80 e. g. : SBP 165 DBP 105 e. g. : SBP 150 DBP 95 Stage 1 Hypertension Prehypertension e. g. : SBP 130 DBP 85 Normal e. g. : SBP 115 DBP 75 120 140 160 Systolic Blood Pressure (SBP) If your systolic pressure falls in one category but your diastolic pressure in another, your level is classified in the higher of the two categories. * JNC 7: The Seventh Report of the Joint National Committee on Prevention, Detection, Evaluation and Treatment of High Blood Pressure National Institute of Health (NIH) Publication; No. Attach the right thumb on the harder part intensely from the side so that the right side of the cuff is sure to be fixed on the side face of the wrist, secure and attach the hook-andloop fastener snugly until not feeling it oppressed. Confirm the both center of wrist and main unit is still on the same line, and tightness of the fixing (Fig. · Pull up on the fastener, without twisting it, to Fig. 4-c remove the unit from your wrist. Center of the wrist Fig. 4-a Correct Position for Blood Pressure Measurement When measuring your blood pressure at your wrist, the pressure cuff must be at heart level to ensure consistent, accurate readings. Always rest for about four to five minutes before taking measurements. Press the On/Off and Start button to start a measurement. The cuff will automatically inflate and then deflate when the measurement is complete. First wrinkle line of wrist-palm joint Taking measurements while sitting down Fig. Rest your elbows on a table or other level surface. Hold the arm so that the cuff is at heart level. 2 cm (3/4") 3. With the palm of the hand facing up, release any tenseness in your muscles. [. . . ] (Re-pressurization was performed several times. ) Pressure decreased suddenly and appeared in the display. mark only blinks a few times, or not at all. Check points Check whether measurements are being taken correctly and whether you are assuming the correct posture. Make sure the unit is on the palm side of the wrist. [. . . ]