User manual PANASONIC EY0230

[. . . ] 10) Do not disassemble charger; take it to a qualified service agent when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire. 11) To reduce risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning. 12) Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress. [. . . ] 22) NOTE: If the supply cord of this appliance is damaged, it must only be replaced by a repair shop appointed by the manufacturer, because special purpose tools are required. 23) The appliance is not intended for use by young children or infirm persons without supervision. 24) Young children should be supervised to ensure that they do not play with the appliance. Note: When you charge the battery pack for the first-time, or after prolonged storage, charge it for about 24 hours to bring the batteries up to full capacity. Sparks may be produced when the plug is inserted into the AC power supply, but this is not a problem in terms of safety. Insert the battery pack firmly into the charger. When charging, cooling fan in the charger functions to cool down the battery pack, and the sound of fan can be heard. If this sound cannot be heard, it is a malfunction. During charging, the charging lamp will light up. Charging will not occur if the battery pack is warm (for example, immediately after heavy-duty operation). The orange standby lamp will light up until the battery becomes cool. When the battery pack has not been used for a long time, the charging lamp starts flashing slowly to indicate protective charging. Protective charging takes longer to fully charge the battery pack, then the standard charging time. If a fully charged battery pack is inserted into the charger again, the charging lamp may light up. After several minutes, the charging lamp may flash quickly to indicate the charging is completed. If the charging lamp does not light immediately after the charger is plugged in, or if after the standard charging time the lamp does not go off, consult an authorized dealer. note: · When a cold battery (of about 5°C or less) is to be charged in a warm room, leave the battery in the room for at least one hour. Charge the battery when the battery temperature has leveled with room temperature. (Failing to do so may result in less than a full charge. ) · Cool down the charger when charging more than two battery packs consecutively. [. . . ] Under no circumstances should either of these wires be connected to the earth terminal of the three pin plug, marked with the letter E or the Earth Symbol . How to replace the fuse: Open the fuse compartment with a screwdriver and replace the fuse and fuse cover if it is removable. Charging will begin when temperature of battery pack drops. Now charging Lit Charging lamp Red Charging is completed Flashing quickly Protective charging Flashing slowly Lit Standby lamp Orange Flashing Battery pack is warm. [. . . ]