User manual PANASONIC EY0L10

[. . . ] 10) Do not disassemble charger; take it to a qualified service agent when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire. 11) To reduce risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning. 1) Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress. [. . . ] Be sure to charge the battery before use. Sparks may be produced when the plug is inserted into the AC power supply, but this is not a problem in terms of safety. Slide the battery dock cover back to allow insertion of the Li-ion battery pack. Verify that the cover is locked securely in place. Insert the battery pack firmly into the charger. When a cold battery (of about 0°C or less) is to be charged in a warm room, leave the battery in the room for at least one hour and charge it when it has warmed up to room temperature. (Failing to do so may result in less than a full charge. ) · Cool down the charger when charging more than two battery packs consecutively. Do not insert your fingers into contact hole, when holding charger or any other occasions. Charging will not start if the battery pack is warm (for example, immediately after heavy-duty operation). When charging is completed, the charging lamp will start flashing quickly in green color. If the temperature of the battery pack is 0°C or less, charging takes longer to fully charge the battery pack than the standard charging time. Even when the battery is fully charged, it will have approximately 50% of the power of a fully charged battery at normal operating temperature. If the power lamp does not light immediately after the charger is plugged in, or if after the standard charging time the charging lamp does not flash quickly in green, consult an authorized dealer. If a fully charged battery pack is inserted into the charger again, the charging lamp lights up. After several minutes, the charging lamp may flash quickly to indicate the charging is completed. Charging will not start if the battery pack is warm (for example, immediately after heavy-duty operation). When charging is completed, the charging lamp will start flashing quickly in green color. If the charging lamp does not light immediately after the charger is plugged in, or if after the standard charging time the charging lamp does not flash quickly in green, consult an authorized dealer. If a fully charged battery pack is inserted into the charger again, the charging lamp lights up. After several minutes, the charging lamp may flash quickly to indicate the charging is completed. When you charge the battery pack for the first time, or after prolonged storage, charge it for about 4 hours to bring the battery up to full capacity. [. . . ] Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 5 amp and that it is approved by ASTA or BSI to BS136. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be purchased from your local Panasonic Dealer. IMPORTANT: The wires in this mains lead are coloured in accordance with the following code: Blue: Neutral Brown: Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. [. . . ]