User manual PANASONIC EY0L80

[. . . ] 10) Do not disassemble charger; take it to a qualified service agent when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire. 11) To reduce risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning. 1) Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress. [. . . ] And wait for more than one hour to warm up the battery to the level of the ambient temperature. Cool down the charger when charging more than two battery packs consecutively. Do not insert your fingers into contact hole, when holding charger or any other occasions. Do not use power source from an engine generator. Your battery pack is not fully charged at the time of purchase. Be sure to charge the battery before use. Sparks may be produced when the plug is inserted into the AC power supply, but this is not a problem in terms of safety. Insert the battery pack firmly into the charger. Line up the alignment marks and place the battery onto the dock on the charger. If the temperature of the battery pack falls approximately below -10°C (14°F), charging will automatically stop to prevent degradation of the battery. Do not charge the battery pack whose temperature is below 0°C (3°F). When charging a cool battery pack (below 0°C (3°F)) in a warm place, leave the battery pack at the place Charging will not start if the battery pack is warm (for example, immedi- When charging is completed, the charging lamp will start flashing quickly in green color. If the power lamp does not light immediately after the charger is plugged in, or if after the standard charging time the charging lamp does not flash quickly in green, consult an authorized dealer. If a fully charged battery pack is inserted into the charger again, the charging lamp lights up. After several minutes, the charging lamp may flash quickly to indicate the charging is completed. Charging will not start if the battery pack is warm (for example, immediately after heavy-duty operation). When charging is completed, the charging lamp will start flashing quickly in green color. If the charging lamp does not light immediately after the charger is plugged in, or if after the standard charging time the charging lamp does not flash quickly in green, consult an authorized dealer. If a fully charged battery pack is inserted into the charger again, the charging lamp lights up. After several minutes, the charging lamp may flash quickly to indicate the charging is completed. [. . . ] Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 5 amp and that it is approved by ASTA or BSI to BS136. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be purchased from your local Panasonic Dealer. IMPORTANT: The wires in this mains lead are coloured in accordance with the following code: Blue: Neutral Brown: Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. [. . . ]