User manual PANASONIC EY3530

[. . . ] 2) Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. Power tools create sparks which may ignite the dust or fumes. 3) Keep bystanders, children, and visitors away while operating a power tool. Distractions can cause you to lose control. [. . . ] To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles. of injury, charge only Battery Pack as shown below. EY9065, EY9066, EY9168, EY9080, EY9086, EY9180, EY9182, EY9001, EY9006, EY9101, EY9106, EY9200, EY9201, EY9136, EY9230, EY9231 EY9251, EY9117, EY9210 Other types of batteries may burst causing personal injury and damage. 4) Do not expose charger to rain or snow. 5) To reduce risk of damaging the electric plug and cord, pull by plug rather than cord when disconnecting charger. 6) Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress. 7) An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used, make sure that: a. pins on plug of extension cord are the same number, size and shape as those of plug on charger. extension cord is properly wired and in good electrical condition. extension cord has a minimum wire size of 16 AWG. CAUTION -To reduce the risk -4- 8) Do not operate charger with damaged cord or plug have qualified serviceman replace them immediately. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. -5- . FUNCTIONAL DESCRIPTION (G) (K) (H) (C) (B) (D) (E) (F) (A) (I) (J) (A) Battery pack (EY9251) (B) Trigger switch (C) Switch lock lever (D) Shoe (E) Shoe lock lever (F) Insulated rubber boot (G) Blade clamp (H) Slider (I) Battery charger (EY0110) (J) Saw blade (K) Blade clamp sleeve -6- . ASSEMBLY WARNING: To reduce the risk of injury, always Selecting a blade remove battery pack before changing the blade. the saw blade is fixed. Make sure that the saw blade is firmly fixed and locked. If the blade clamp does not lock properly, have the tool serviced by a qualified repair personnel. Blade The blade clamp sleeve can be used with all 1/2" shank universal reciprocating saw blade. When selecting a blade, choose the right type and length. Choose a length long enough to extend beyond the shoe and your work throughout the stroke. Do not use blades less than 3-9/16" (90 mm) long since they will not extend beyond the shoe throughout the stroke. Installing or removing the saw blade CAUTION: Always clean out all chips or foreign material adhering to the blade, blade clamp and/or slider before use. Failure to do so may cause insufficient tightening of the blade, resulting in a serious injury. [. . . ] When in any of the conditions that battery pack is too cool, or the battery pack has not been used for a long time, the charging lamp is lit. In this case, charging takes longer to fully charge the battery pack, than the standard charging time. If a fully charged battery pack is inserted into the charger again, the charging lamp light up. After several minutes, the charging lamp may flash quickly to indicate the charging is completed. [. . . ]