User manual PANASONIC EY3544GQK

[. . . ] Ordinary eye or sun glasses are NOT safety glasses. 6) When this tool is used for woodworking in confined areas (e. Inspect workpiece for any nails and remove them before operation. 9) Check for the proper clearance beyond the workpiece before cutting so that the blade will not strike the floor, workbench, etc. [. . . ] To start the motor, press the switch lock lever, then squeeze the trigger switch. To reduce the risk of injury, keep hands away from the blade and other moving parts. Press the switch lock lever, which can be pressed in from either left or right side of the tool. Allow the tool to come to a complete stop before removing the blade from a partial cut or before laying the tool down. Always wear gloves to protect your hands from flying hot chips when cutting metal. Always use a suitable coolant (cutting oil) when cutting metal. If the tool is operated continuously until the battery pack has discharged, allow the tool to rest for 15 minutes before proceeding with a fresh battery pack. Bring the blade into light contact with the workpiece. First, make a pilot groove, using a slower speed. Then use a faster speed to continue cutting. The reciprocating saw is equipped with a trigger speed control switch. It may be operated at any speed from zero stroke per minute to full speed. Always start tool before blade contacts the workpiece. To vary the speed, simply increase or decrease the pressure on the trigger. The further the trigger is pulled, the greater the speed. For Appropriate use of Battery pack ni-MH Battery pack (EY9251) Charge the Ni-MH battery fully before storage in order to ensure a longer service life. the ambient temperature range is between 0°C (32°F) and 40°C (104°F). If the battery pack is used when the battery temperature is below 0°C (32°F), the tool may fail to function properly. in that case , charge the battery until charging is completed for appropriate functioning of the battery. When battery pack is not in use, keep it away from other metal objects like: paper clips, coins, keys, nails, screws, or other small metal objects that can make a connection from one terminal to another. Before the blade contacts the workpiece, grasp the handle firmly and pull the trigger. Begin cutting at slow speed, gradually increasing speed as you cut. [. . . ] If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be purchased from your local Panasonic Dealer. IMPORTANT: The wires in this mains lead are coloured in accordance with the following code: Blue:Neutral Brown: Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the letter N or coloured BLACK. [. . . ]