User manual PANASONIC EY3654

[. . . ] Do not use tool while tired or under the influence of drugs, alcohol, or medication. A moment of inattention while operating power tools may result in serious personal injury. Keep your hair, clothing, and gloves away from moving parts. Loose clothes, jewelry, or long hair can be caught in moving parts. [. . . ] EY9065, EY9066, EY9080, EY9086, EY9180, EY9182, EY9001, EY9006, EY9101, EY9106, EY9107, EY9200, EY9201, EY9136, EY9230, EY9231 Other types of batteries may burst causing personal injury and damage. 4) Do not expose charger to rain or snow. 5) To reduce risk of damaging the electric plug and cord, pull by plug rather than cord when disconnecting charger. 6) Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress. -4- 7) An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used, make sure: a. that pins on plug of extension cord are the same number, size and shape as those of plug on charger. that extension cord is properly wired and in good electrical condition. that wire size is large enough for ampere rating of charger as specified below. RECOMMENDED MINIMUM AWG SIZE OF EXTENSION CORDS FOR BATTERY CHARGERS AC Input Rating. Amperes AWG Size of Cord Equal to or But less Length of Cord, Feet greater than than 25 50 100 150 0 2 18 18 18 16 15) Do not store the tool and battery pack in locations where the temperature may reach or exceed 50°C (122°F) (such a metal tool shed, or a car in the summer), which can lead to deterioration of the storage battery. 16) Do not charge battery pack when the temperature is BELOW 0°C (32°F) or ABOVE 40°C (104°F). FUNCTIONAL DESCRIPTION Clutch handle Keyless drill chuck Speed selector switch Vent holes Forward/Reverse lever Battery pack release button Variable speed control trigger 15. 6V Battery pack (EY9231) Battery charger (EY0230) . ASSEMBLY Attaching or removing bit Lock collar Note: When attaching or removing a bit, disconnect battery pack from tool or place the switch in the center position (switch lock). This tool is equipped with a keyless drill chuck. FREE 1. Attachment Insert the bit and turn the Lock collar clockwise (looking from the front) to tighten firmly. Slide the Lock collar to LOCK side until it snaps. Lock collar Note: If excessive play occurs in the chuck, secure the drill in place and tighten the chuck by turning clockwise, open the chuck jaws by unscrewing the Lock collar and tighten the screw (left-handed screw) with a screwdriver by turning it counterclockwise (viewed from the front). LOCK 2. Removal Slide the Lock collar to FREE side. Turn the Lock collar counterclockwise (looking from the front), then remove the bit. -6- Attaching or removing battery pack 1. To connect the battery pack: Insert the battery pack. It snaps into place to indicate proper connection. To remove the battery pack: Press the two buttons on the sides of the battery pack. Slide the battery pack out of the tool body. drilling. [. . . ] Note: When charging a cool battery pack (below 15°C (41°F) in a warm place, leave the battery pack at the place and wait for more than one hour to warm up the battery to the level of the ambient temperature. (Battery pack may not be fully charged. ) Cool down the charger when charging more than two battery packs consecutively. Do not insert your fingers into contact hole, when holding charger or any other occasions. Do not use power source from an engine generator. [. . . ]