User manual PANASONIC EY37A1

[. . . ] 1) 1 it the projection portion to the notch F and attach the nozzle. Slide the battery pack until it locks into position. To remove the battery pack: Push the button and slide the battery pack forward. The wind power increases with the amount of depression of the trigger. [. . . ] Clean the terminals before charging the battery pack if any foreign substances are found on the terminals. Indb 6 2013-7-24 11:03:43 The life of the battery pack terminals may be affected by foreign substances such as dust and water etc. Or battery, be sure to note the following when carrying out operation. I f the battery becomes hot, the protection function will be activated and the battery will stop operating. The battery pack is designed to be installed by proceeding two steps for safety. Make sure the battery pack is installed properly to the main unit before use. If the battery pack is not connected firmly when the switch is switched on, the main unit will not rotate normally. Connect the battery pack into the body of the tool until the red or yellow label disappears. T CAUTION:  o protect the motor ●● ●● Cool down the charger when charging more than two battery packs consecutively. Do not insert your fingers into contact hole, when holding charger or any other occasions. —● For safe use ●● To prevent the risk of fire or damage to the battery charger. Do not cover vent holes on the charger and the battery pack. —● ●● CAUTION: NOTE: Your battery pack is not fully charged at the time of purchase. Be sure to charge the battery before use. Sparks may be produced when the plug is inserted into the AC power supply, but this is not a problem in terms of safety. Connect the battery pack firmly into the charger. During charging, the charging lamp will be illuminated. when charging is completed , an internal electronic switch will automatically be triggered to prevent overcharging. Charging will not start if the battery pack is warm (for example, immediately after heavy-duty operation). The orange standby lamp will be flashing until the battery cools down. The charge lamp (green) will flash slowly once the battery is approximately 80% charged. When charging is completed, the charging lamp in green color will turn off. [. . . ] A replacement fuse cover can be purchased from your local Panasonic Dealer. If a new plug is to be fitted please observe the wiring code as shown below. Sørg for at sætte batteripakningsdækslet på for at beskytte batteriterminalerne. Når du oplader batteripakningen, skal du bekræfte at terminalerne på batteriopladeren er fri for uvedkommende substanser, som for eksempel støv og vand etc. [. . . ]