User manual PANASONIC EY6225C

[. . . ] Hold the bit holder and pull it against the driver. The bit holder will return to its original position when released. Pull the bit to make sure it does not come out. 1) Be aware that this tool is always in an operating condition, since it does not have to be plugged into an electrical outlet. [. . . ] Insert the battery pack firmly into the charger. B Charging will not start if the battery pack is warm (for example, immediately after heavy-duty operation). If a fully charged battery pack is inserted into the charger again, the charging lamp may light up and then flash slowly. After several minutes, the charging lamp may flash quickly to indicate the charging is completed. If the charging lamp does not light immediately after the charger is plugged in, or if after the standard charging time the lamp does not go off, consult an authorized dealer. nOTE: · When a cold battery (of about 5°C or less) is to be charged in a warm room, leave the battery in the room for at least one hour and charge it when it has warmed up to room temperature. (Failing to do so may result in less than a full charge. ) · Cool down the charger when charging more than two battery packs consecutively. cAUTION: · Do not use power source from an engine generator. Push the upper half of the switch for forward rotation, or the lower half for reverse rotation. To suit the application of this tool, two different rotational speeds are available. Depending upon use, either the high or low speed should be selected. LOW HIGH 200/min (RPM) 600/min (RPM) strong torque less torque CAUTION: Check rotational speed selection before operating this tool. After use, set the main switch lock at the lock position to prevent accidental operation. Press the battery pack release buttons on both sides and pull the pack away from the tool. After the charging has been completed, remove the battery pack from the charger and connect it to the tool. Disconnect the charger form the power source when not in use. If operation time becomes extremely short after recharging, replace the battery pack with a new one. [. . . ] IMPORTANT: The wires in this mains lead Are coloured in accordance with the following code: Blue: Neutral Brown: Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the letter N or coloured BLACK. The wire which is coloured BROWN must be connected to the terminal in the plug which is marked with the letter L or coloured RED. Under no circumstances should either of these wires be connected to the earth terminal of the three pin plug, marked with the letter E or the Earth Symbol L . [. . . ]