User manual PANASONIC EY6225CQ

[. . . ] A moment of inattention while operating power tools may result in serious personal injury. Keep your hair, clothing, and gloves away from moving parts. Loose clothes, jewelry, or long hair can be caught in moving parts. Be sure switch is in the locked or off position before inserting battery pack. [. . . ] EY9065, EY9066, EY9168, EY9080, EY9086, EY9180, EY9182, EY9001, EY9006, EY9101, EY9106, EY9200, EY9201, EY9136, EY9230, EY9231, EY9251, EY9117, EY9210 Other types of batteries may burst causing personal injury and damage. 4) Do not expose charger to rain or snow. 5) To reduce risk of damaging the electric plug and cord, pull by plug rather than cord when disconnecting charger. 6) Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress. 7) An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used, make sure that: a. pins on plug of extension cord are the same number, size and shape as those of plug on charger. extension cord is properly wired and in good electrical condition. wire size is large enough for ampere rating of charger as specified below. CAUTION - To reduce the risk -4- RECOMMENDED MINIMUM AWG SIZE OF EXTENSION CORDS FOR BATTERY CHARGERS AC Input Rating. Amperes AWG Size of Cord Equal to or But less Length of Cord, Feet greater than than 25 50 100 150 0 2 18 18 18 16 8) Do not operate charger with damaged cord or plug -- replace them immediately. 9) Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. -5- . FUNCTIONAL DESCRIPTION (A) (B) (E) (K) (I) (C) (D) (J) (F) (G) (H) (A) Keyless drill chuck (EY9799) (B) Clutch handle (C) Forward / Reverse lever (D) Variable speed control trigger (E) Speed selector switch (F) Bit holder (G) Battery pack(EY9251) (H) Battery pack release button (I) Battery charger (EY0110) (J) Support handle (K) Vent holes -6- Attaching or removing bit NOTE: When attaching or removing a bit, disconnect battery pack from tool or place the switch in the center position (switch lock). This tool is equipped with a keyless drill chuck. Attachment Insert the bit and turn the lock collar clockwise (looking from the front) to tighten firmly until it stops clicking. . ASSEMBLY Attaching or removing battery pack 1. To connect the battery pack: Insert the battery pack. It snaps into place to indicate proper connection. To remove the battery pack: Press the two buttons on the sides of the battery pack. Slide the battery pack out of the tool body. Support handle Place the support handle at your favorite position and tighten the handle securely. 2. Removal Turn the lock collar counterclockwise (looking from the front), then remove the bit. Lock collar Loosen Tighten Remove the handle when placing the tool in the storage case. . OPERATION 3. Storage Keep the bit in bit holder when not in use. Remove the battery pack to expose the bit storage compartment inside the handle housing. [. . . ] NOTE: When you charge the battery pack for the first time, or after prolonged storage, charge it for about 24 hours to bring the battery up to full capacity. Charging 3. During charging, the charging lamp will be lit. When charging is completed, an internal electronic switch will automatically be triggered to prevent overcharging. Charging will not start if the battery pack is warm (for example, immediately after heavy-duty operation). [. . . ]