User manual PANASONIC EY6405

[. . . ] A moment of inattention while operating power tools may result in serious personal injury. Keep your hair, clothing, and gloves away from moving parts. Loose clothes, jewelry, or long hair can be caught in moving parts. Be sure switch is in the locked or off position before inserting battery pack. [. . . ] Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used, make sure: a. that pins on plug of extension cord are the same number, size and shape as those of plug on charger. that extension cord is properly wired and in good electrical condition. that wire size is large enough for ampere rating of charger as specified below. CAUTION -To reduce the risk WARNING; Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: * Lead from lead-based paints * Crystalline silica from bricks and cement and other masonry products * Arsenic and chromium from chemically-treated lumber. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as dust masks that are specially designed to filter our microscopic particles. -4- RECOMMENDED MINIMUM AWG SIZE OF EXTENSION CORDS FOR BATTERY CHARGERS AC Input Rating. Amperes AWG Size of Cord Equal to or But less Length of Cord, Feet greater than than 25 50 100 150 0 2 18 18 18 16 8) Do not operate charger with damaged cord or plug replace them immediately. 9) Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman. 10) Do not disassemble charger; take it to a qualified serviceman when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire. This tool is equipped with a keyless drill chuck. 1. Attachment Insert the bit and turn the Lock collar clockwise (looking from the front) to tighten firmly until it stops clicking. Lock collar Note: If excessive play occurs in the chuck, secure the drill in place and tighten the chuck by turning clockwise, open the chuck jaws by unscrewing the Lock collar and tighten the screw (left-handed screw) with a screwdriver by turning it counterclockwise (viewed from the front). 2. Removal Slide the Lock collar to FREE side. Turn the Lock collar counterclockwise (looking from the front), then remove the bit. -6- Attaching or removing battery pack 1. To connect the battery pack: Insert the battery pack. It snaps into place to indicate proper connection. To remove the battery pack: Press the two buttons on the sides of the battery pack. Slide the battery pack out of the tool body. Support handle Place the support handle at your favorite position and tighten the handle securely. CAUTION: Do not operate Forward/ Reverse lever until the chuck comes to a complete stop. Shifting during rotation of the chuck may damage the tool. Forward Rotation Switch Operation 1. For forward rotation, set the lever to forward. [. . . ] When in any of the conditions that battery pack is too cool, or the battery pack has not been used for a long time, the charging lamp is lit. In this case, charging takes longer to fully charge the battery pack, than the standard charging time. If a fully charged battery pack is inserted into the charger again, the charging lamp may light up and then flash slowly. After several minutes, the charging lamp may flash quickly to indicate the charging is completed. [. . . ]