User manual PANASONIC EY6813NQKW

[. . . ] Do not use a damp cloth, thinner, benzine, or other volatile solvents for cleaning. 7) When storing or carrying the tool , set the Forward/Reverse lever to the center position (switch lock). 8) Do not strain the tool by holding the speed control trigger halfway (speed control mode) so that the motor stops. The protection circuit will activate and may prevent speed control operation. [. . . ] If the battery pack is used when the battery temperature is below 0°C (32°F), the tool may fail to function properly. NOTE: Charge a new battery pack, or a battery pack that has not been used for a prolonged time, for about 24 hours to bring the battery up to full charge. Insert the battery pack firmly into the charger. If a fully charged battery pack is inserted into the charger again, the charging lamp may light up. After several minutes, the charging lamp may flash quickly to indicate the charging is completed. If the charging lamp does not light immediately after the charger is plugged in, or if after the standard charging time the lamp does not go off, consult an authorized dealer. NOTE: When a cold battery (of about 5°C (41°F) or less) is to be charged in a warm room, leave the battery in the room for at least one hour and charge it when it has warmed up to room temperature. (Failing to do so may result in less than a full charge. ) Cool down the charger when charging more than two batterypacks consecutively. Do not insert your fingers into contact hole, when holding charger or any other occasions. CAUTION: Do not use power source from an engine generator. To AC outlet Battery pack Battry pack During charging, the charging lamp will light up. when the charge is completed , an internal electronic switch will automatically be triggered to prevent overcharging. Charging will not occur if the battery pack is warm (for example, immediately after heavy-duty operation). The orange standby lamp will light up until the battery becomes cool. When the battery pack has not been used for a long time, the charging lamp starts flashing slowly to indicate protective charging. Protective charging takes longer to fully charge the battery pack, than the standard charging time. Flashing Lit Flashing quickly Flashing slowly Lit Flashing Charger is plugged into a wall outlet. Charging will begin when temperature of battery pack drops. Red Flashing Red Lit Green Flashing quickly Orange Lit Orange Flashing Charger is plugged into the AC outlet. Charging will begin when temperature of battery pack drops. * Drill bits of which diameter is 20 mm above cannot be inserted through dust collection cup. [. . . ] If the plug contains a removable fuse cover you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be purchased from your local Panasonic Dealer. IMPORTANT: The wires in this mains lead are coloured in accordance with the following code: Blue:Neutral Brown: Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. [. . . ]