User manual PANASONIC EY6903

[. . . ] 10) The appliance is not intended for use by young children or infirm persons without supervision. 11) Young children should be supervised to ensure that they do not play with the appliance. Disconnect battery pack from tool or place the switch in the center position (switch lock). This tool is equipped with a keyless drill chuck. [. . . ] in that case , charge the battery until charging is completed for appropriate functioning of the battery. When battery pack is not in use, keep it away from other metal objects like: paper clips, coins, keys, nails, screws, or other small metal objects that can make a connection from one terminal to another. shorting the battery terminals together may cause sparks , burns or a fire. When operating with a Ni-MH battery pack, make sure the place is well-ventilated. Choose a low or high speed to suit the use. The more the speed control trigger is pulled, the higher the speed becomes. CAUTION: Check the speed selector switch before use. Use at low speed when strong force is needed during operation. (Using at high speed while a strong force is applied may cause a motor breakdown. ) Do not operate the speed selector switch (LOW-HIGH) while pulling on the speed control trigger. This can cause the rechargeable battery to wear quickly or damage the internal mechanism of the motor. If operation time becomes extremely short after recharging, replace the battery pack with a new one. note: Use under extremely hot or cold conditions will reduce operating capacity per charge. ATTENTION: For environmental protection and recycling of materials, be sure that it is disposed of at an officially assigned location, if there is one in your country. Note: When you charge the battery pack for the first time, or after prolonged storage, charge it for about 24 hours to bring the batteries up to full capacity. Note: Sparks may be produced when the plug is inserted into the AC power supply, but this is not a problem in terms of safety. Insert the battery pack firmly into the charger. Charging will not start if the battery pack is warm (for example, immediately after heavy-duty operation). When charging is completed, the charging lamp will start flashing quickly in green color. When in any of the conditions that battery pack is too cool, or the bat- Tery pack has not been used for a long time, the charging lamp is lit. In this case charging takes longer to fully charge the battery pack, than the standard charging time. If a fully charged battery pack is inserted into the charger again, the charging lamp light up. [. . . ] check for the ASTA mark or the BSI mark on the body of the fuse. If the plug contains a removable fuse cover you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be purchased from your local Panasonic Dealer. [. . . ]