User manual PANASONIC EY6950GQKW

[. . . ] 10) Young children should be supervised to ensure that they do not play with appliance. Attachment Insert the bit and turn the Lock collar clockwise (looking from the front) to tighten firmly until it stops clicking. Removal Turn the Lock collar counterclockwise (looking from the front), then remove the bit. Remove the battery pack to expose the bit storage compartment inside the handle housing. [. . . ] ) Do not operate the speed selector switch (LOW-HIGH) while pulling on the speed control trigger. This can cause the rechargeable battery to wear quickly or damage the internal mechanism of the motor. CAUTION: To eliminate excessive temperature increase of the tool surface, do not operate the tool continuously using two or more battery packs. Tool needs cool off time before switching to another pack. Do not close up vent holes on body sides of the body during operation. Use the machine in such a way as to prevent the air from the body vent holes from blowing directly onto your skin. When operating with a Ni-MH battery pack, make sure the place is well-ventilated. Place, the tool can be used as a manual screwdriver (up to 22. There will be a little play in the chuck, but this is not a malfunction. This feature is handy for tightening screws that require more torque than the maximum torque of the driver (position on the clutch), for confirming the tightness of a screw or to loosen an extremely tight screw. For Appropriate use of Battery pack ni-MH Battery pack (EY9251) Charge the Ni-MH battery fully before storage in order to ensure a longer service life. the ambient temperature range is between 0°C (32°F) and 40°C (104°F). If the battery pack is used when the battery temperature is below 0°C (32°F), the tool may fail to function properly. in that case , charge the battery until charging is completed for appropriate functioning of the battery. When battery pack is not in use, keep it away from other metal objects like: paper clips, coins, keys, nails, screws, or other small metal objects that can make a connection from one terminal to another. shorting the battery terminals together may cause sparks , burns or a fire. When operating with a Ni-MH battery pack, make sure the place is well-ventilated. If operation time becomes extremely short after recharging, replace the battery pack with a new one. With the trigger switch not engaged and a screwdriver bit locked in NOTE: When you charge the battery pack for the first time, or after prolonged storage, charge it for about 24 hours to bring the batteries up to full capacity. NOTE: Sparks may be produced when the plug is inserted into the AC power supply, but this is not a problem in terms of safety. Insert the battery pack firmly into the charger. This case charging takes longer to fully charge the battery pack, than the standard charging time. [. . . ] If the plug contains a removable fuse cover you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be purchased from your local Panasonic Dealer. As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. [. . . ]