User manual PANASONIC EY7270

[. . . ] If the collar does not return to its original position or the bit comes out when pulled on, the bit has not been properly attached. Make sure the bit is properly attached before use. Attaching Socket Attach the socket by sliding the female detent on the bottom of the socket to the square drive on the body. When attaching or removing a bit or socket, disconnect battery pack from tool or place the trigger switch in the center position (switch lock). [. . . ] Take out the belt hook and insert into the other side of the slot on the main unit. Fasten the screw firmly, turning it clockwise. The belt hook can be taken out from the main unit only when it is at storing position. Charge the Ni-MH battery fully before storage in order to ensure a longer service life. If the battery pack is used when the battery temperature is below 0°C (3°F), the tool may fail to function properly. When battery pack is not in use, keep it away from other metal objects such as paper clips, coins, keys, nails, screws, or other small metal objects that can make a connection from one terminal to another. When operating with a Ni-MH battery pack, make sure the area is well ventilated. the rechargeable batteries have a limited life. If the operation time becomes extremely short after recharging, replace the battery pack with a new one. Pull the belt hook from 2 storing position 2 and 1 set it. Release the belt hook 3 lock lever to lock the angle of belt hook. Also make sure the belt hook lock lever is firmly locked into position 3. The belt hook cannot be locked in this position. Firmly lock it into position before use. To return the belt hook to the storing position, Follow step 1. To secure the lock, follow 3 and 4 above. The belt hook can be attached to either side of the unit. Loosen the screw turning it counterFor environmental protection and recycling of materials, be sure that it is disposed of at an officially assigned location, if there is one in your country. When you charge the battery pack for the first time, or after prolonged storage, charge it for about 4 hours to bring the battery up to full capacity. Sparks may be produced when the plug is inserted into the AC power supply, but this is not a problem in terms of safety. Insert the battery pack firmly into the charger. If the battery pack is too cool, or the battery pack has not been used for a long time, the charging lamp will light up. [. . . ] 6) Switch (Variable speed control trigger) Torque is lowered if the unit is used with the switch not fully pulled out. 7) Effect of connecting adaptor The tightening torque will be lowered through the use of a universal joint or a connecting adaptor. Model Screw driving Use only bits suitable for size of drill's chuck. Wood screw Tech screw Model Motor voltage No load speed Maximum torque Impact per minute Overall length Weight (with battery pack) EY771 1 V DC Soft impact mode: 0 - 1000/min (rpm) Medium impact mode: 0 - 1400/min (rpm) Hard impact mode: 0 - 300/min (rpm) 135 Nm 165 Nm (1380 kgf-cm, 1190 in-lbs. [. . . ]