User manual PANASONIC EY7410LA2S

[. . . ] The collar will return to its original position when it is released. Pull the bit to make sure it does not come out. No load speed Revolutions or reciprocations per minutes Electrical capacity of battery pack Rotation only Read the operating instructions before use. Tery loses its charge, causing the battery low warning lamp to flash. [. . . ] Do not insert your fingers into contact hole, when holding charger or any other occasions. Do not use power source from an engine generator. Your battery pack is not fully charged at the time of purchase. Be sure to charge the battery before use. If the operation time becomes extremely short after recharging, replace the battery pack with a new one. Sparks may be produced when the plug is inserted into the AC power supply, but this is not a problem in terms of safety. Slide the battery dock cover back to allow insertion of the Li-ion battery pack. Verify that the cover is locked securely in place. Insert the battery pack firmly into the charger. For environmental protection and recycling of materials, be sure that it is disposed of at an officially assigned location, if there is one in your country. When a cold battery (of about 0°C or less) is to be charged in a warm Charging will not start if the battery pack is warm (for example, immediately after heavy-duty operation). When charging is completed, the charging lamp will start flashing quickly in green color. If the temperature of the battery pack is 0°C or less, charging takes longer to fully charge the battery pack than the standard charging time. Even when the battery is fully charged, it will have approximately 50% of the power of a fully charged battery at normal operating temperature. If the power lamp does not light immediately after the charger is plugged in, or if after the standard charging time the charging lamp does not flash quickly in green, consult an authorized dealer. If a fully charged battery pack is inserted into the charger again, the charging lamp lights up. After several minutes, the charging lamp may flash quickly to indicate the charging is completed. Supply, but this is not a problem in terms of safety. Slide the battery dock cover back to allow insertion of the Ni-Cd battery pack. Insert the battery pack firmly into the charger. When you charge the battery pack for the first time, or after prolonged storage, charge it for about 4 hours to bring the battery up to full capacity. Charging will not start if the battery pack is warm (for example, immediately after heavy-duty operation). [. . . ] A replacement fuse cover can be purchased from your local Panasonic Dealer. IMPORTANT: The wires in this mains lead are coloured in accordance with the following code: Blue: Neutral Brown: Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the letter N or coloured BLACK. The wire which is coloured BROWN must be connected to the terminal in the plug which is marked with the letter L or coloured RED. [. . . ]