User manual PANASONIC EYFLA2

[. . . ] When attaching or removing a bit, disconnect battery pack from tool or place the switch in the center position (switch lock). Hold the collar of quick connect chuck and pull it out from the tool. The collar will return to its original position when it is released. Pull the bit to make sure it does not come out. [. . . ] Be sure to fully charge the battery pack in question after activation of the automatic power-off function. Failure to do so may prevent the automatic power-off function from being properly deactivated. User: Manner in which the tool is applied to the bolt, strength with which the tool is held, manner in which the tool's switch is engaged · Condition of object being tightened: Material, seating surface finish Setting the tool to configuration mode 1. Engage the switch while pushing the butbutton and then release both the ton and the switch. After all the LED lamps have turned off, the control panel will flash and change to configuration mode. The torque control function calculates the load from the motor's rotational angle during the hammer impact and determines that the bolt has been properly seated when a preset load value is exceeded. Driving is then automatically stopped after a preset number of impacts have been delivered to the bolt. cAUTION: · Always check the tool's tightening torque before use. Always operate the tool with the switch fully engaged. The torque control function will not operate when the switch is not sufficiently engaged, preventing the tool from stopping automatically. In work where a heavy load comes to bear during tightening, the load may be interpreted as the seating of the bolt, preventing the bolt from being completely tightened. Repeated tightening of the same bolt may break the bolt or deform the material into which the bolt is being driven as a result of excessive tightening. The tightening torque value and precision vary with factors such as the material into which the bolt is being driven and the condition of the socket being used. Adjust the torque as necessary for the work being performed. Tools ship from the factory set to "F" mode (torque control function off). The control panel will turn off if the tool is not operated for a period of 5 minutes. You can select from 30 torque clutch settings (1 to 30). Use figures from the Tightening Torque Chart to guide your selection of torque clutch setting. You must press the OK button in order for the selected setting to take effect. Be sure to verify the new value after changing the setting. ) Tightening Torque Chart (for Reference Use) The values illustrated on this chart were measured under the conditions described below and are provided for reference purposes. Actual tightening torque varies with ambient conditions (the particular bolt being tightened, hardware being used, method of holding the bolt in place, etc. [. . . ] If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be purchased from your local Panasonic Dealer. The wires in this mains lead are coloured in accordance with the following code: Blue: Neutral Brown: Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the letter N or coloured BLACK. [. . . ]