User manual PANASONIC FV-08VK1

[. . . ] For disposal or recycling information, please contact your local authorities or the Electronics Industries Alliance:http://www. eiae. org Only for FV-11VHL2. 3. This product must be properly grounded. GENERAL SAFETY INFORMATION CONTINUED WARNING: To reduce the risk of fire, electric shock or injury to persons, observe the following: A. Use this unit only in the manner intended by the manufacturer. If you have any questions, please contact the manufacturer. [. . . ] Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction. Neither unauthorized modification, repair nor disassembly is allowed. Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel buming equipment to prevent backdrafting. Follow the heating equipment manufacturer's guideline and safety standards such as those published by the National Fire Protection Association (NFPA), and the American Society for Heating Refrigeration and Air Conditioning Engineers (ASHRAE) and the local code authorities. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities. Ducted fans must always be vented to the outdoors. Solid state controls may cause harmonic distortion which can cause motor humming noise. To reduce the risk of fire or electric shock, do not use this unit with any solid-state control device. Before servicing or cleaning unit, switch power off at service panel and lock panel cabinet to prevent power from being switched on accidentally. Ceiling hole should be aligned with the edge of the flange. (Fig. 8) Slot 12 Night lamp 5/8 7. Install the circular duct (4 inches) to the adaptor and secure it with duct tape or clamps. (Fig. 7) (31 Fluorescent lamp Mounting spring 9. Install the fluorescent lamps and then install the night lamp. Insert mounting springs into slots as shown and mount grille to fan body. (Fig. 9) Note:Do not mount grille and springs conversely. If the grille is mounted in the opposite direction, the grille can not be fitted to the ceiling, so then reverse the grille position and try to mount again. Incorrect Grille Switch labels (Fig. 10) For Model FV-11VHL2 For Model FV-08VK1 9) Fig. 8 Fig. 9 Switch labels Fig. 10 INSTALLATION (BETWEEN JOIST MOUNTING) Suspension bracket Illustrations in this manual common use the image of FV-11VHL2. Before installation, remove warning lable and the tape that is securing the adapter and the damper. [. . . ] Before installation, remove warning lable and the tape that is securing the adapter and the damper. (Fig. 1) Fig. 11 (Select the suspension bracket according to spacing A as shown below. ) B Fan body Suspension bracket Suspension bracket Fig. 11 Joists Spacing A on center joists 16 inches B 13 1/4 ~ 15 1/2 (336~394) Adaptor 19. 2 inches horizontal joists 14 3/4 ~ 16 3/4 (374~425) 19. 2 inches vertical joists 16 1/2 ~ 18 3/4 (419~476) Fan body Junction box Suspension bracket Fig. 12 Keep the distance C (1/2 inch, 12. 7 mm) for the thickness of ceiling board. C Fig. 12 INSTALLATION (BETWEEN JOIST MOUNTING) CONTINUED Fig. 13, Fig. 14 Joist 2 Long screws (ST4. 2X20) Fig. 13 Fig. 14 2-Screw (ST4. 2X12) 4 Long screws (ST4. 2X20) Joist 6. Follow step 5 of installation installation work. (page 7) to complete the Fig. 14 INSTALLATION (WOODEN HEADER INSTALLATION) Ceiling joist 1. Before installation, remove warning lable and the tape that is securing the adapter and the damper. [. . . ]