User manual PANASONIC FV-11VHL2

[. . . ] Make sure that all duct work is properly vented. DO NOT INSTALL THIS UNIT OVER A BATHTUB OR SHOWER ENCLOSURE. [. . . ] Never place a switch where it can be reached from a tub or shower. Not to be installed in a ceiling thermally insulated to a value greater than R40. (This is required for installation in Canada only. ) J. Use only on 20 ampere branch circuit. WIRING DIAGRAM Circulating fan unit Black Motor(C) Red Circulating fan unit Black PCB Fuse (20A) Thermal cut-off (230oF (110oC)) Lighting unit Fuse Thermal cut-off o o Black (20A) (230 F (110 C)) Black Motor(C) Red Fluorescent lamp White Heater (1400W) Thermostat o (140oF (60C)) White White PCB Heater (1400W) Thermostat (140oF (60oC)) White Electronic ballast Fuse (3. 15A) White Black Ventilating fan unit Red Motor(V) White Black Capacitor Ventilating fan unit Red White Capacitor Motor(V) Black White Black White Black White White Black White Black OFF ON Black Black Junction box Green Switch(not included) Night lamp Junction box Green Switch(not included) Switch(not included) OFF Switch(not included) OFF Switch(not included) OFF OFF ON ON ON ON OFF ON Earth ground Power Supply AC120V 60Hz Power Supply AC120V 60Hz Earth ground Power Supply Power Supply Power Supply AC120V 60Hz AC120V 60Hz AC120V 60Hz INSTALLATION (JOIST MOUNTING- ) Illustrations in this manual common use the image of FV-11VHL2, and mark for FV-11VHL2 only, others are same for FV-11VH2. Before installation, remove warning lable and the tape that is securing the adapter and the damper. (Fig. 1) Warning label Tape Suspension bracket Fan body Suspension bracket Suspension bracket Fig. 2-1 Suspension bracket Fan body Fig. 1 2. Insert the suspension bracket into the fan body. (Select the suspension bracket as shown below. ) Fan body Fig. 2-2 Suspension bracket Suspension Suspension bracket bracket Fan body Joists Fig. 2-3 Joist Fan body 16 inches and 19. 2 inches horizontal joists 4 Long screws (ST4. 2X20) Fig. 3 2 Long screws (ST4. 2X20) 2 Screw (ST4. 2X8) Suspension bracket Suspension bracket Joist Screw (ST4. 2X12) Fig. 4-1 Screw (ST4. 2X12) (Fig. 3) Joist 16 inches and 19. 2 inches horizontal joists refer to Fig. 4-1, 19. 2 inches vertical joists and 24 inches refer to Fig. 4-2. 2 Long screws (ST4. 2X20) Fig. 4-2 INSTALLATION (JOIST MOUNTING- ) CONTINUED 5. Remove the lighting cord out from hook (FV-11VHL2), then remove junction box plate and secure conduit or stress relief to wiring box knock-out hole. (Fig. 5) 6. Refer to wiring diagram (Page. 5) Follow all the local electrical safety codes. As well as the National Electrical Code (NEC). Using UL approved wire nuts, connect house power wires to ventilating fan wires (Fig. 6): Black to black; white to white; green to green. Make sure all connections are fastened firmly after wiring is finished. Replace the junction box plate, and then replace lighting cord to hook. [. . . ] 60 oC(140 oF). Fig. 17 Fig. 17 Fig. 18 Fig. 18 Fig. 19 Vacuum cleaner Fig. 19 Fig. 20 5. Fig. 20 MAINTENANCE (REPLACEMENT OF LAMP) 4. [. . . ]