User manual PANASONIC HCX900EF

[. . . ] Please note that the actual controls and components, menu items, etc. of your High Definition Video Camera may look somewhat different from those shown in the illustrations in these Operating Instructions. Before use Remove the connector cover. How to replace the fuse The location of the fuse differ according to the type of AC mains plug (figures A and B). Confirm the AC mains plug fitted and follow the instructions below. Illustrations may differ from actual AC mains plug. [. . . ] ≥ All enquiries transactions and distribution facilities are provided directly by Panasonic UK. ≥ Also available through our Internet is direct shopping for a wide range of finished products. Take a browse on our website for further details. 8 VQT4Q37 HC-V520&V520M&V510EP&EB_VQT4Q37_mst. book 9 ページ ２０１３年１月７日　月曜日　午前１０時４３分 Accessories Check the accessories before using this unit. (l 14) Install the battery by inserting it in the direction shown in the figure. Removing the battery Be sure to hold down the power button until the status indicator goes off. Then remove the battery while supporting the unit to prevent it from dropping. Move the battery release lever in the direction indicated by the arrow and remove the battery when unlocked. A Battery holder Insert the battery until it clicks and locks. 10 VQT4Q37 HC-V520&V520M&V510EP&EB_VQT4Q37_mst. book 11 ページ ２０１３年１月７日　月曜日　午前１０時４３分 Charging the battery When this unit is purchased, the battery is not charged. Charge the battery fully before using this unit for the first time. The unit is in the standby condition when the AC adaptor is connected. The primary circuit is always “live” as long as the AC adaptor is connected to an electrical outlet. Important: ≥ Do not use the AC cable with any other equipment as it is designed only for this unit. Also, do not use the AC cable from other equipment with this unit. ≥ Touching the touch screen will not operate while you are touching another part of the touch screen. ∫ Slide while touching Move your finger while pressing on the touch screen. 14 VQT4Q37 HC-V520&V520M&V510EP&EB_VQT4Q37_mst. book 15 ページ ２０１３年１月７日　月曜日　午前１０時４３分 ∫ About the operation icons / / / : Touch when changing a page or performing settings. : Touch to return to the previous screen. About the Touch Menu Touch (left side)/ (right side) of on the Touch Menu to switch the operation icons. ≥ It is also possible to switch the operation icons by  sliding the Touch Menu right or left while touching it. T W A Touch Menu ∫ To display the Touch Menu Display of the Touch Menu will disappear when no touch operation is performed for a specific period of time during recording of motion picture/still picture. To display it again, touch . VQT4Q37 15 HC-V520&V520M&V510EP&EB_VQT4Q37_mst. book 16 ページ ２０１３年１月７日　月曜日　午前１０時４３分 Preparation Setting date and time The clock is not set at the time of purchase. Make sure to set the clock. 1 2 A Select the menu. (l 21) : [SETUP] # [CLOCK SET] MENU Touch the date or time to be set, then set the desired value using / . 3 Displaying the World Time setting: [HOME]/ [DESTINATION] ≥ The year can be set between 2000 and 2039. Touch [ENTER]. ≥ A message prompting for World Time setting may be displayed. Perform the World Time setting by touching the screen. ≥ Touch [EXIT] to complete the setting. ≥ HC-V520 / HC-V520M At the time of purchase, the confirmation screen for the Wi-Fi setup is displayed after setting the world time. Exit the screen if the setup is not necessary. ≥ When the unit is turned on for the first time, a message asking you to set the date and time will appear. Select [YES] and perform Steps 2 to 3 to set the date and time. [. . . ] Recording media: SD Memory Card SDHC Memory Card SDXC Memory Card Refer to the operating instructions (PDF format) for details on SD cards usable in this unit. HC-V520M Built-in memory; 16 GB 25 HC-V520&V520M&V510EP&EB_VQT4Q37_mst. book 26 ページ ２０１３年１月７日　月曜日　午前１０時４３分 Minimum required illumination: Approx. 4 lx (1/25 with Low Light Mode in the Scene Mode) Approx. 1 lx with the Colour Night View function AV connector video output level: 1. 0 Vp-p, 75 h, PAL system HDMI mini connector video output level: HDMI™ (x. v. Colour™) 1080p/1080i/576p AV connector audio output level (Line): 251 mV, 600 h, 2 ch HDMI mini connector audio output level: [AVCHD]; Dolby Digital/Linear PCM [iFrame], [MP4]; Linear PCM USB: Reader function SD card; Read only (No copyright protection support) HC-V520M Built-in memory; Read only Hi-Speed USB (USB 2. 0), USB terminal Type Mini AB USB host function (for USB HDD) Battery charging function (Charges from USB terminal when the main unit is off) Dimensions: 53 mm (W)k61 mm (H)k116 mm (D) (including projecting parts) Mass: HC-V520 Approx. 229 g [without battery (supplied) and an SD card (optional)] HC-V520M Approx. [. . . ]