User manual PANASONIC HE08018E

[. . . ] This allows you to switch between Auto Focus (AF) and Manual Focus (MF). €¢ When either the [AF/MF] switch of the lens or the setting of the camera is set to [MF], Manual Focus (MF) is enabled. [AF/MF] switch H-E08018 E 5 6 7 Lens fitting mark Contact points Lens mount rubber DVQX1250ZA F0317KD0 Note • When recording on the wide-angle side and using the flash, the periphery of the screen may darken. in such cases , we recommend using the external flash. [. . . ] 5 inch) (from the tip of the lens to the base side of the lens mount) Mass Approx. 694 lb) Operating temperature j10 oC to 40 oC (14 oF to 104 oF) Dust-proof and splash-proof Available Manufactured by: Panasonic Corporation Kadoma, Osaka, Japan Importer for Europe: Panasonic Marketing Europe GmbH Panasonic Testing Centre Winsbergring 15, 22525 Hamburg, Germany For information on how to attach and remove the lens, refer to the operating instructions for your digital camera. €¢ Before attaching or detaching the lens, check that the digital camera is turned off. €¢ Before attaching the lens to the digital camera, remove the lens rear cap A by rotating it in the direction of the arrow. (See illustration ) • To prevent dust and other particles from accumulating on or entering the lens, be sure to attach the lens cap/lens rear cap after detaching the lens from the digital camera. Com  Panasonic Corporation 2017 • If you use two or more filters at the same time, part of a recorded image may darken. €¢ It is possible to attach the lens cap with the filter already attached. €¢ When using the lens hood and a filter at the same time, attach the filter first. €¢ You cannot attach a conversion lens or adaptor to this lens. A filter may be used, but attaching any other element may cause damage to the lens. ˆ« Filter aufsetzen ∫ Attaching the Lens Hood (Supplied Accessory) (See illustration / ) Hold the lens hood with your fingers placed as shown in the picture (B). €¢ Do not hold the lens hood in a way that twists or bends it. When using it, please be careful of the following. If the lens is not working properly, consult the dealer or your nearest Service Centre. – Please attach the lens to a dust-proof and splashproof digital camera. €“ When attaching or removing the lens, be careful so that foreign materials such as sand, dust, and water droplets do not adhere to or enter the lens mount rubber, contact points, digital camera and lens. €“ This lens is not waterproof and cannot be used to record underwater. For splash-proofing, the lens is constructed to resist the entry of water. Do adhere to the lens, wipe after use with a soft dry cloth. €¢ To improve the dust-proofing and splash-proofing of this lens, a lens mount rubber is used in the mounting portion. After changing the lens a number of times, you may find that the lens mount rubber has marked the mount portion of the digital camera body, which does not affect its performance. For information on changing the lens mount rubber, contact your nearest Service Centre. [. . . ] Panasonic Authorised Service Centres are located in major metropolitan areas and most regional centres of Australia, however, coverage will vary dependant on product. For advice on exact Authorised Service Centre locations for your product, please telephone our Customer Care Centre on 132600 or visit our website and use the Service Centre Locator. In addition to your rights under this warranty, Panasonic products come with consumer guarantees that cannot be excluded under the Australian Consumer Law. If there is a major failure with the product, you can reject the product and elect to have a refund or to have the product replaced or if you wish you may elect to keep the goods and be compensated for the drop in value of the goods. [. . . ]