User manual PANASONIC HFS014045

[. . . ] Alternatively, in some countries you may be able to return your products to your local retailer upon the purchase of an equivalent new product. Disposing of this product correctly will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. Please contact your local authority for further details of your nearest designated collection point. Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation. [. . . ] If condensation occurs, turn the power off and leave it for about two hours. Once the camera acclimatises to the surrounding temperature the condensation will go away naturally. [Inspection to be performed when you unpack the unit] When removing the unit from its packing box, check that the main unit and the supplied accessories are there and also check their external appearance and functions to verify that they have not sustained any damage during distribution and transportation. If you discover any trouble, contact your vendor before using the product. 2 Align the lens fitting marks B (red marks) on the camera body and the lens and then rotate the lens in the direction of the arrow until it clicks. ⷠDo not press the lens release button when you attach a lens. ⷠDo not try to attach the lens when holding it at an angle to the camera body as the lens mount may get scratched. Attaching the Lens Hood (Supplied Accessory) Insert the lens hood into the lens with the short sides at the top and bottom, and turn in the direction of the arrow until it stops. Press the lens release button C while turning the lens as far as possible in the direction of the arrow to detach it. Attach the body cap to the camera so no dirt or dust will get inside the main unit. 2 Reverse the lens hood and then attach it in the same way as shown previously. When taking pictures with the flash with the lens hood attached, the lower portion of the screen may turn dark (vignetting effect) and the control of the flash may be disabled because the photo flash may be obscured by the lens hood. When using the AF assist lamp in the dark, detach the lens hood. Edges of pictures may be cut off if more than one PL filter (optional) or MC protector (optional) is used or if thick filters and/or protectors are used. Rotate the zoom ring when you wish to take large (tele) or wide (wide angle) pictures. The stabilizer function may not be effective in the following cases. ­ When taking pictures while following a moving subject. ­ When the shutter speed becomes slower to take pictures indoors or in dark places. Rotate to focus when taking pictures with manual focus. Take care not to drop or knock the lens. [. . . ] If the internal parts require inspection or repair, take the unit to the vendor. Do not use benzine, thinner, alcohol or other similar cleaning agents to clean the lens glass or exterior cabinet. Using solvents can damage the lens or cause the paint to peel. Wipe off any dust or fingerprints with a soft, dry cloth. [. . . ]