User manual PANASONIC HHS-043E

[. . . ] failure to do so may result in performance failure caused by mold , etc. It is recommended that you check the unit’s operation prior to use. € Do not leave the lens in contact with rubber or plastic products for extended periods of time. € Do not disassemble or alter the unit. [. . . ] When this lens is attached to digital camera, stabiliser function cannot be turned off or stabiliser function does not work. € The Optical Image Stabiliser function of this lens only works correctly with supported cameras. > When older Panasonic digital cameras (DMC-GF1, DMC-GH1, DMC-G1) are used, [Stabilizer] in the [Rec] mode menu cannot be set to [OFF]. It is recommended to update the firmware of the digital camera at the following website. Jp/support/global/cs/dsc/download/ > When using this lens with another make of digital cameras, contact the respective company about details. ˆ Attaching the Lens (See illustration ) Align the lens fitting marks A on the camera body and the lens and then rotate the lens in the direction of the arrow until it clicks. Com ∫ Detaching the Lens (See illustration • Do not press the lens release button B when you attach a lens. € Do not try to attach the lens when holding it at an angle to the camera body as the lens mount may get scratched. • Check that the lens is attached correctly. ˆ Gegenlichtblende aufsetzen (Mitgeliefertes 1  Panasonic Corporation 2015 ) While pressing on the lens release button B, rotate the lens toward the arrow until it stops and then remove. € When rotating the lens, hold C, the portion near the base of the lens. € Attach the lens rear cap so that the lens contact point does not get scratched. € Attach the body cap to the camera so no dirt or dust will get inside the main unit. Vermeidung von Störungen Specifications Specifications are subject to change without notice. 31 m to ¶ [from the focus distance reference line] Maximum image magnification 0. ] switch None (Setting of the [Stabilizer] is done in [Rec] mode menu by LUMIX digital cameras. 50 mm (from the tip of the lens to the base side of the lens mount) Mass Approx. 130 g ∫ Objektivpflege 1 VFC4456 2 SYF0059 3 VFC4605 ∫ Attaching the Lens Hood (Supplied 1 2 3 4 SYQ0374 SYQ0375 5 SDW0170K SDW0170S Accessory) (See illustration ) Rotate the decoration ring D in the direction of the arrow and then remove. Align the mark E ( ) on the lens hood with the mark on the tip of the lens. Rotate the lens hood in the direction of the arrow ) on until it clicks and then align the mark F ( the lens hood with the mark on the tip of the lens. 130 g Hinweis Precautions ∫ Lens Care 1 2 3 4 5 1 2 3 • Sand and dust can damage the lens. Make sure that no sand or dust gets inside the lens or the terminals when using the lens on a beach, etc. [. . . ] Panasonic Authorised Service Centres are located in major metropolitan areas and most regional centres of Australia, however, coverage will vary dependant on product. For advice on exact Authorised Service Centre locations for your product, please telephone our Customer Care Centre on 132600 or visit our website and use the Service Centre Locator. In addition to your rights under this warranty, Panasonic products come with consumer guarantees that cannot be excluded under the Australian Consumer Law. If there is a major failure with the product, you can reject the product and elect to have a refund or to have the product replaced or if you wish you may elect to keep the goods and be compensated for the drop in value of the goods. [. . . ]