User manual PANASONIC HNS043E

[. . . ] Then reinsert the battery and/ or reconnect the AC adaptor and turn the camera on. The lens can be used with a digital camera compatible with the lens mount standard for the “Micro Four ThirdsTM System”. Book 3 ページ ２０１４年１月７日　火曜日　午後７時５８分 ENGLISH -If you see this symbol- Precautions Disposal of Old Equipment Only for European Union and countries with recycling systems This symbol on the products, packaging, and/or accompanying documents means that used electrical and electronic products must not be mixed with general household waste. For proper treatment, recovery and recycling of old products, please take them to applicable collection points in accordance with your national legislation. [. . . ] ‰¥ If you set the camera to Aperture-Priority AE Mode or Manual Exposure Mode, the aperture value of the ring will be enabled. ‰¥ If you set the position of the aperture ring to [A], the aperture value of the camera will be enabled. 6 Lens fitting mark 7 Contact points 3 Focus ring Rotate to focus when taking pictures with manual focus (MF). Note ≥ If you tilt the lens, the lenses inside may move. ‰¥ If you turn off the camera, the aperture will be set to a reduced value. Book 6 ページ ２０１４年１月７日　火曜日　午後７時５８分 ≥ When flash recording with a close subject, the light of the flash will be blocked by the lens and part of the picture may be dark. Check the distance from the subject when recording. ‰¥ Operating sounds may be recorded when autofocusing during motion picture recording. If operating sounds become bothersome, we recommend setting to manual focus (MF) and fixing focus before recording to avoid recording the lens noise. ] to [ON] when recording a motion picture, operating sounds may be recorded. If they become bothersome, we recommend setting the [O. ‰¥ The aperture can be adjusted with the aperture ring only when a Panasonic digital camera is attached to the lens. (As of January 2014) Attaching/Detaching the Lens Check that the camera is turned off. ‰¥ Remove the lens rear cap from the lens. ˆ« Attaching the Lens Align the lens fitting marks A on the camera body and the lens and then rotate the lens in the direction of the arrow until it clicks. €¢ Do not press the lens release button B when you attach a lens. €¢ Do not try to attach the lens when holding it at an angle to the camera body as the lens mount may get scratched. • Check that the lens is attached correctly. €¢ Be sure to remove the lens cap when recording. Book 7 ページ ２０１４年１月７日　火曜日　午後７時５８分 ∫ Detaching the Lens While pressing on the lens release button B, rotate the lens toward the arrow until it stops and then remove. €¢ Attach the lens rear cap so that the lens contact point does not get scratched. €¢ Attach the body cap to the camera so no dirt or dust will get inside the main unit. [. . . ] ‰¥ Do not touch the lens contact point. ‰¥ Do not disassemble or alter the unit. Do not use benzine, thinner, alcohol or other similar cleaning agents to clean the lens glass or exterior cabinet. ‰¥ Using solvents can damage the lens or cause the paint to peel. [. . . ]