User manual PANASONIC HQ2141RH

[. . . ] These symbols (with a blue background) denote actions that are COMPULSORY. INSTALLATION PRECAUTIONS · Due to the weight of this product, we recommend that you have a helper to assist in the installation. To avoid injury, use the proper method of lifting. · Make sure the window frame to be used can properly support this product. [. . . ] The damper is opened and room air is drawn out. Display Panel MODE selection pad FAN SPEED selection pad TEMPERATURE/TIMER setting pad TIMER pad Timer SET/CANCEL pad OPERATION OFF/ON pad AIR SWING pad ECONOMY pad TYPES OF SIGNAL SOUND One long "Beep" and one short "Beep". (Sound from the main unit. ) 3 PART IDENTIFICATION 1 2 3 4 5 6 7 8 9 ACCESSORIES · Remote control · Two R03 dry-cell batteries 1 OPERATION REMOTE CONTROL Signal Transmitter OPERATION button TEMPERATURE/TIMER setting button TIMER button TIMER SET/CANCEL button MODE selection button ECONOMY Button AIR SWING button Fan Speed Selection Button 2 TEMP/TIMER SET/ CANCEL 3 5 7 9 TIMER 4 6 8 MODE AIR SWING ECONOMY FAN SPEED Be sure to observe the following: · Aim remote control at control panel on air conditioner when operating. · Do not drop or throw the remote control. · Do not place the remote control in a location that is exposed to direct sunlight or next to a heating unit or other heat sources. °C hr COOL FAN HIGH LOW FAN SPEED MODE TEMP/TIMER TIMER SET OPERATION SET/ CANCEL OFF/ON AIR SWING POWERFUL Remote Wireles s Control · Maximum distance : 10 m (32. 8 ft. ) 4 PREPARATION BEFORE OPERATING WARNING Ensure that the power plug is securely inserted. A loose plug may cause a fire or an electric shock. HOW TO INSERT BATTERIES NOTES · If the unit is not going to be used for an extended period of time, remove the power plug. Otherwise, approximately 2. 5W of electricity will be used even if the unit has been turned off using the remote control. · If operation is stopped, and to be restarted immediately, the unit will resume operation only after 3 minutes. ABOUT THE BATTERIES 1 Open the cover. CAUTION OPERATION 2 Insert the two batteries. °F hr 3 Close the cover. · · · The batteries can be used for approximately one year. Be sure to replace the batteries with two new identical batteries. Simultaneously, the display will show the setting temperature. CHECK TEMPERATURE/MODE/FAN SPEED SETTING DURING ON TIMER TIMER °F hr °F hr TIMER TIMER TEMP/TIMER Press the TIMER button. The TIMER indicator light will blink and the previous temperature setting will be shown. Simultaneously, MODE and FAN SPEED indicator will light up. This indication will last for 5 seconds, and then the display will show the remaining time. MODE and FAN SPEED indicator light will turn off. At this time, the TIMER indicator light is steady instead of blinking. SET/ CANCEL CHANGE TEMPERATURE/MODE/FAN SPEED SETTING DURING ON TIMER SET CHECK TIMER SETTING DURING OFF TIMER °F SET/ CANCEL °F hr TIMER hr °F hr Press the TIMER button to check the remaining programmed timer setting. The figure will be displayed for 10 seconds then will automatically switch back to temperature setting. NOTE The timer figure will change according to the time remaining (if you set it to turn off 3 hours from now, the timer will show "2" at an hour later). OPERATION OFF/ON SET/ CANCEL °F hr TIMER OPERATION °F TIMER hr Press the SET/CANCEL button to cancel the timer setting. Then press OPERATION button to stop operation. Start the TIMER setting again by repeating the step from the "Setting the on timer" procedures). TIMER CANCEL TIMER SETTING DURING ON TIMER SET SET/ CANCEL °F hr CANCEL TIMER SETTING DURING OFF TIMER SET OPERATION OFF/ON SET/ CANCEL °F hr SET/ CANCEL Press the SET/CANCEL button to cancel the timer setting. The SET/CANCEL indicator light will turn off. [. . . ] If you hear other noises, please consult your nearest servicenter. · Humidity is high. · Condensed water is overflowing. · To rectify the problem, mount an optional drain pan to the unit. Condition 5 If water drips inside the room. Condition 2 · · · · If the unit does not operate. · The unit is tilted inward. To rectify this, tilt the unit slightly outward. [. . . ]