User manual PANASONIC HRS100400E

[. . . ] €¢ Four ThirdsTM and Four Thirds Logo marks are trademarks or registered trademarks of Olympus Imaging Corporation, in Japan, the United States, the European Union and other countries. The LEICA DG lenses are manufactured using measurement instruments and quality assurance systems that have been certified by Leica Camera AG based on the company’s quality standards. €¢ Other names of systems and products mentioned in these instructions are usually the registered trademarks or trademarks of the manufacturers who developed the system or product concerned. Book 3 ページ ２０１６年１月１９日　火曜日　午前９時３５分 ENGLISH -If you see this symbolDisposal of Old Equipment Only for European Union and countries with recycling systems This symbol on the products, packaging, and/or accompanying documents means that used electrical and electronic products must not be mixed with general household waste. [. . . ] When carrying the lens, rotate this ring to lock the zoom ring to prevent the lens from extending under its own weight. 10 Focusing distance range selector switch [FULL]: It can focus between the ranges of 1. [5m-¶]: It can focus between the ranges of 5. The speed of focusing with auto focus will be faster. 11 Lens fitting mark 12 Lens mount rubber 13 Contact points 5 SQT1200 SQT1200_E. Book 6 ページ ２０１６年１月１９日　火曜日　午前９時３５分 Note • If you zoom after focusing, focusing errors may occur. After zooming, please perform the focusing again. €¢ In very quiet situations Auto Focus operating sounds may be recorded during motion picture recording. in such situations , switching to Manual Focus will improve the situation. To [ON] when recording a motion picture, operating sounds may be recorded. If they become bothersome, we recommend setting the O. €¢ After detaching the lens from the digital camera, be sure to attach the lens cap/lens rear cap. ˆ« Attaching Filters • Vignetting may occur if using 2 or more filters at the same time. €¢ It is possible to attach the lens cap or the supplied lens hood with the filter already attached. €¢ You cannot attach a conversion lens or adaptor to this lens. A filter may be used, but attaching any other element may cause damage to the lens. Using the Lens Hoods The lens comes with a built-in slide lens hood and supplied lens hood. With the latter, you can block extra light even more effectively. €¢ The built-in slide lens hood and supplied lens hood can be used together at the same time. €¢ To use the built-in slide lens hood, slide it in the direction of the arrow. We recommend locking the zoom ring with the zoom lock ring before performing operations. Attaching/Detaching the Lens For information on how to attach and remove the lens, refer to the operating instructions for your digital camera. [. . . ] €¢ Under no circumstances should the unit be stored in any of the following locations since doing so may cause problems in operation or malfunctioning. €“ In direct sunlight or on a beach in summer – In locations with high temperatures and humidity levels or where the changes in temperature and humidity are acute – In locations with high concentrations of sand, dust or dirt – Where there is fire – Near heaters, air conditioners or humidifiers – Where water may make the unit wet – Where there is vibration – Inside a vehicle • Refer also to the operating instructions of the digital camera. €¢ When the unit is not going to be used for a prolonged period, we recommend storing with a desiccant (silica gel). failure to do so may result in performance failure caused by mold , etc. [. . . ]