User manual PANASONIC H-VS014140E

[. . . ] ‰¥ Micro Four ThirdsTM and Micro Four Thirds Logo marks are trademarks or registered trademarks of Olympus Imaging Corporation, in Japan, the United States, the European Union and other countries. ‰¥ Other names, company names, and product names printed in these instructions are trademarks or registered trademarks of the companies concerned. Book 3 ページ ２００９年３月１２日　木曜日　午後４時３分 ENGLISH -If you see this symbol- Information on Disposal for Users of Waste Electrical & Electronic Equipment (private households) This symbol on the products and/or accompanying documents means that used electrical and electronic products should not be mixed with general household waste. For proper treatment, recovery and recycling, please take these products to designated collection points, where they will be accepted on a free of charge basis. [. . . ] ˆ« Attaching the Lens ≥ Check that the camera is turned off. A: Lens Rear Cap      1 2 3 4 VFC4430 VYC0997 VYF3250 VFC4315 1 2 3 4 Lens Storage Bag Lens Hood Lens Cap Lens Rear Cap (The lens cap and lens rear cap are attached to the interchangeable lens at the time of purchase. ) 2 Align the lens fitting marks B (red marks) on the camera body and the lens and then rotate the lens in the direction of the arrow until it clicks. €¢ Do not press the lens release button when you attach a lens. €¢ Do not try to attach the lens when holding it at an angle to the camera body as the lens mount may get scratched. Book 6 ページ ２００９年３月１３日　金曜日　午前１０時１３分 ∫Detaching the Lens ≥ Check that the camera is turned off. ˆ« Attaching the Lens Hood (Supplied Accessory) Insert the lens hood into the lens with the short sides at the top and bottom, and turn in the direction of the arrow until it stops. Press the lens release button C while turning the lens as far as possible in the direction of the arrow to detach it. €¢ Attach the lens rear cap so that the lens contact point does not get scratched. €¢ Attach the body cap to the camera so no dirt or dust will get inside the main unit. ρƒ D: Fit to the mark ∫Attaching and Detaching the Lens Cap ≥ Be careful not to lose the lens cap. ˆ« Temporarily Storing the Lens Hood 1 Turn the lens hood in the direction of the arrow to detach it. Book 7 ページ ２００９年３月１２日　木曜日　午後４時３分 2 Reverse the lens hood and then attach it in the same way as shown previously. ‰¥ When taking pictures with the flash with the lens hood attached, the lower portion of the screen may turn dark (vignetting effect) and the control of the flash may be disabled because the photo flash may be obscured by the lens hood. ‰¥ When using the AF assist lamp in the dark, detach the lens hood. ˆ« Attaching Filters ≥ Vignetting may occur if using 2 or more MC protectors (optional), PL filters (optional) or ND filters (optional), or if using thick protectors and/or filters. Book 8 ページ ２００９年３月１２日　木曜日　午後４時３分 Names and Functions of Components ∫Lens 3 Zoom ring Rotate the zoom ring when you wish to take large (tele) or wide (wide angle) pictures. ] switch When the lens is attached to the camera the stabilizer function is set to activate if the [O. ‰¥ The stabilizer function may not be effective in the following cases. €“ When taking pictures while following a moving subject. [. . . ] ‰¥ Use a dry, dust cloth to remove dirt and dust on the zoom ring and focus ring. ≥ Do not use a household detergent or a chemically treated cloth. Troubleshooting A sound is heard when the camera is turned on or off. ‰¥ This is the sound of lens or aperture movement and is not a malfunction. [. . . ]