User manual PANASONIC H-X015E

[. . . ] ‰¥ Four ThirdsTM and Four Thirds Logo marks are trademarks or registered trademarks of Olympus Imaging Corporation, in Japan, the United States, the European Union and other countries. The LEICA DG lenses are manufactured using measurement instruments and quality assurance systems that have been certified by Leica Camera AG based on the company’s quality standards. ‰¥ Other names of systems and products mentioned in these instructions are usually the registered trademarks or trademarks of the manufacturers who developed the system or product concerned. Book 3 ページ ２０１４年４月１１日　金曜日　午前９時１７分 ENGLISH -If you see this symbol- Precautions Disposal of Old Equipment Only for European Union and countries with recycling systems This symbol on the products, packaging, and/or accompanying documents means that used electrical and electronic products must not be mixed with general household waste. [. . . ] ‰¥ Remove the lens rear cap from the lens. 5 [AF/MF] switch This allows you to switch between Auto Focus (AF) and Manual Focus (MF). If you set [MF], you can use the focus ring to adjust the focus. ‰¥ When either the [AF/MF] switch of the lens or the setting of the camera is set to [MF], Manual Focus (MF) is enabled. ˆ« Attaching the Lens Align the lens fitting marks A on the camera body and the lens and then rotate the lens in the direction of the arrow until it clicks. €¢ Do not press the lens release button B when you attach a lens. €¢ Do not try to attach the lens when holding it at an angle to the camera body as the lens mount may get scratched. • Check that the lens is attached correctly. €¢ Be sure to remove the lens cap when recording. 6 Lens fitting mark 7 Contact points Note ≥ When using this lens and the flash to record a subject very close to the camera, it is possible that a darker shadowed area may appear in the lower portion of the picture. This situation is not a malfunction and is caused when the flash is partially blocked by the lens. This situation may be worsened when the lens hood is used. ‰¥ In very quiet situations Auto Focus operating sounds may be recorded during motion picture recording. in such situations , switching to Manual Focus will improve the situation. ‰¥ The aperture can be adjusted with the aperture ring only when a Panasonic digital camera is attached to the lens. (As of April 2014) 6 SQT0244 SQT0244_E. Book 7 ページ ２０１４年４月１１日　金曜日　午前９時１７分 ∫ Detaching the Lens While pressing on the lens release button B, rotate the lens toward the arrow until it stops and then remove. €¢ Attach the lens rear cap so that the lens contact point does not get scratched. €¢ Attach the body cap to the camera so no dirt or dust will get inside the main unit. 3 Rotate the lens hood in the direction of the arrow until it clicks into place, and align the stop position E on the lens hood with the index on the tip of the lens. 2 3 ∫ Attaching the Lens Hood (Supplied Accessory) ≥ Before attaching the lens hood, make sure to remove the lens cap. The lens hood cannot be attached unless you remove the lens cap. [. . . ] ‰¥ Do not leave the lens in contact with rubber or plastic products for extended periods of time. ‰¥ Do not touch the lens contact point. ‰¥ Do not disassemble or alter the unit. Do not use benzine, thinner, alcohol or other similar cleaning agents to clean the lens glass or exterior cabinet. [. . . ]