User manual PANASONIC KITE21HB4EA

[. . . ] ⷠDo not attempt to repair the unit by yourself. Do not install the unit in a potentially explosive atmosphere. ⷠDo not wash the unit with water, benzene, thinner or scouring powder. ⷠDo not use for other purposes such as preservation of food. [. . . ] Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation. For business users in the European Union If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information. [Information on Disposal in other Countries outside the European Union] These symbols are only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal. Note for the battery symbol (bottom two symbol examples): This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the Directive for the chemical involved. Do not switch ON the unit when waxing the floor. After waxing, aerate the room properly before operating the unit. ⷠDo not install the unit in oily and smoky areas. Use this air conditioner under the following temperature range (CU-E10HBEA, CU-E15HBEA, CU-E18HBEA, CU-E21HBEA) Temperature (°C) COOLING HEATING Maximum Minimum Maximum Minimum Indoor *DBT 32 16 30 16 *WBT 23 11 *DBT 43 -10 24 -10 Outdoor *WBT 26 18 - This unit is still able to operate as a cooler with outdoor temperature as low as -10°C in a non-living room, such as a computer room, with a room temperature of 16°C or above, and room humidity up to 80%. When the outdoor temperature drops to -10°C, compressor will be cut off and resume operation again once the temperature rises to more than -10°C. ⷠWhen the outdoor temperature is out of the above temperature range, the heating capacity will drop signifi cantly and outdoor unit might stop for protection control. The operation mode priority is given to the first unit that turned on. ⷠDuring operation, heating and cooling mode could not be activated at the same time for different indoor unit. ⷠThe power indicator blinks to indicate the indoor unit is standing by for different operation mode. Room A Outdoor unit Automatic Press and hold until you Force 2 hear one beep, then release. Press and Normal 3 hold until you hear two cooling beeps, then release. Press and Force 4 hold until you hear three heating beeps, then release. Please be aware of the OFF indication on the remote control display to prevent the unit from starting/stopping improperly. Operating the unit within the recommended temperature could induce energy saving. Unit selects operation mode every 30 minutes according to temperature setting, outdoor and room temperature. During operation mode selection the power indicator blinks. [. . . ] This may due to damp smell emitted by the wall, carpet, furniture or clothing. Indoor fan stops occasionally during automatic · Operation is delayed a few minutes after · Power indicator blinks during operation and · The unit is in defrost mode, and the melted frost is drained from the the indoor fan is stopped. Indoor fan stops occasionally during heating · Power indicator blinks before the unit is · This is a preliminary step in preparation for the operation when the ON switched on. Cracking sound can be heard during · Close all doors and windows. [. . . ]