User manual PANASONIC KITE9HKEA

[. . . ] ⷠDo not attempt to repair the unit by yourself. Do not install the unit in a potentially explosive atmosphere. ⷠDo not wash the unit with water, benzene, thinner or scouring powder. ⷠDo not use for other purposes such as preservation of food. [. . . ] Wiring colour may vary depending on a country wiring code's standard. eNVIRONMENTAL REQUIREMENTS Battery Disposal The batteries must be recycled or disposed of properly. END-OF-LIFE DISPOSAL "Instructions for end-user" for air conditioners: This air conditioner bears the above mark, indicating that electrical equipment should not be disposed of alongside general household waste. European Community countries (*), should have a dedicated collection system for these products. Do not try to dismantle the system yourself as this could have harmful effects on your health and on the environment as a result of incorrect waste handling. This dismantling and disposal of refrigerant, oil and other parts must be done by a qualified installer in accordance with relevant local and national regulations. Air conditioners must be treated at a specialized treatment facility for re-use, recycling and recovery and should not be disposed of in the municipal waste stream. Please contact your installer, dealer or local authority for more information. Penalties may also be applicable for incorrect disposal of waste products, in accordance with national legislation. *subject to the national law of each member state Information on Disposal in other countries outside the European Union This symbol is only valid in the European Union. If you wish to discard this product, please contact your installer, dealer or local authority and ask for the correct method of disposal. ⷠDo not switch ON the unit when waxing the floor. After waxing, aerate the room properly before operating the unit. ⷠDo not install the unit in oily and smoky areas. Ionizer Supersonic air purifying device Do not touch during operation. Automatic Press and hold until you Force 2 hear one beep, then release. Press and Normal 3 hold until you hear two cooling beeps, then release. Press and Force 4 hold until you hear three heating beeps, then release. Please be aware of the OFF indication on the remote control display to prevent the unit from starting/stopping improperly. Operating the unit within the recommended temperature could induce energy saving. [. . . ] The following symptoms do not indicate malfunction. This may due to damp smell emitted by the wall, carpet, furniture or clothing. Indoor fan stops occasionally during automatic · Operation is delayed a few minutes after · Power indicator blinks during operation and · The unit is in defrost mode, and the melted frost is drained from the the indoor fan is stopped. Indoor fan stops occasionally during heating · Power indicator blinks before the unit is · This is a preliminary step in preparation for the operation when the ON switched on. [. . . ]