User manual PANASONIC KITF43DTE8

[. . . ] ENGLISH 2 ~ 11 Before operating the unit, read these operating instructions thoroughly and keep them for future reference. DEFINITION The instructions to be followed are classified by the following symbols: this symbol denotes an action that is PROHIBITED. These symbols denote actions that are COMPULSORY. To prevent personal injury, injury to others, or property damage, please observe the following. [. . . ] Press and hold until you hear 2 beeps then release. Press and pull out Insert AAA or R03 batteries (can be used ~ 1 year) Press CLOCK Unit selects operation mode according to temperature setting, outdoor and room temperature. hEAT mode - To enjoy warm air · Unit takes a while to warm up. (Applicable for Inverter / Heat-pump Model) FAN mode - To enables air circulation in the room COOL mode - To enjoy cool air DRY mode - To dehumidify the environment · Unit operates at low fan speed to give a gentle cooling operation. ⷠDuring soft dry operation, the indoor fan operates at a low fan speed. ⷠThe louvers movement might not align with the remote control display. To turn ON or OFF the unit at a preset time. For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. ⷠIf the operation mode is set to Fan, the fan speed will be fixed at MEDIUM regardless of the temperature setting. Auto Air Swing function optimize room comfort by giving finer control over the airflow direction. When ON timer is set, the unit may start early before the actual set time in order to achieve the desired temperature on time. If the main power is switched off for an hour or more, the clock and timer will need to be set again. The airflow direction can be adjusted as desired by using remote control. tO REDUCE POWER ECONOMY CONSUMPTION · Recommend to use when desired room temperature is reached. ⷠEconomy operation can be activated in all modes and can be cancelled by pressing the respective button again. To avoid unintentional operation, you can assign a different address to each indoor unit. ⷠPress repeatedly to select your desired address setting. Helps to remove unpleasant odour from the surrounding area during operation. To enable this function, press the ODOUR WASH for more than 3 seconds. ⷠThe unit will automatically perform Fan and Heating modes for approximately 20 minutes and then stops automatically. You do not need to change this setting for normal operation. ⷠIf the address is set to GROUP, more than one indoor unit can be operated at the same time. [. . . ] If you want to set together with your desired Switch off the power supply before cleaning. ⷠDo not touch the aluminium fin, sharp parts may cause injury. hINTS · Clean the filter regularly for best performance and to reduce power consumption. Do not use water hotter than 40°C. [. . . ]