User manual PANASONIC KV-S2025C SERIES

[. . . ] Before reading these instructions, please read the installation manual enclosed with this unit. Please carefully read these instructions, the enclosed installation manual and maintenance manual. Keep all documentation in a safe place for future reference. Do not expose the CD-ROM to direct sunlight or extreme heat and do not scratch or smudge the surface of the CD-ROM. [. . . ] Exit stopper Exit extension tray ≥ When using small sized documents like business cards, raise the business card guides and the business card stopper. Caution: Do not use the business card guides and the business card stopper for larger documents than their acceptable size. A Business card guides Business card stopper 5 Place the documents on the feed tray with the side to be scanned facing up. ‰¥ Be sure to place the documents on the feed tray as shown in the figure on the right. ‰¥ The amount of documents should not exceed the limit mark on the document guide. Remove dirt and dust from the radiation vent with a brush. Radiation vent ∫ Inside the scanner ≥ Clean the unit at least once a week or when 20, 000 sheets have been scanned, whichever comes first. ‰¥ Clean the rollers and sensors if paper jamming or multiple-sheet feeding occurs frequently. ) ≥ Clean the CIS glasses and sensor rollers when lines appear on the scanned images. ) ≥ If the documents you scan are dirty, then the scanner components will also become dirty. To maintain proper scanning, clean the scanner components frequently. 22 Cleaning the Unit ∫ Cleaning the rollers and sensors Roller cleaning paper: Open the bag on the dotted line and take out the roller cleaning paper. ‰¥ If the roller cleaning paper bag is left opened for a long period of time before using it, the alcohol will evaporate. Please use the roller cleaning paper immediately after opening the bag. dotted line The roller cleaning paper (Model No. KV-SS03) is available from the dealer where you purchased your scanner. 2 Push the ADF door release to open the ADF door. 23 Cleaning the Unit 3 Use the roller cleaning paper (KV-SS03) to remove the dirt from the surfaces of the retard roller, paper feed roller, separation roller, 6 drive rollers, and 6 free rollers. Also, remove dust on the paper sensors (Paper detector, Waiting sensor, Starting position sensor) and reflector sheets with a cotton swab. ‰¥ When wiping off the dirt on the roller surfaces, hold the rollers to prevent them from rotating, and wipe the rollers all the way around them proceeding from one end to the other in the directions of the arrows shown in the figure on the right. Paper detector Retard roller Reflector sheets Drive rollers Waiting sensor Drive rollers Paper feed roller Separation roller Free rollers Free rollers Starting position sensor 4 Clean the reflector sheet for the ending sensor. ‰¥ Remove dust on the reflector sheet of the ending sensor with a cotton swab. [. . . ] The ADF does not open when the ADF door release is pushed. 37 Troubleshooting Symptom The document has been loaded on the feed tray. But the scanner does not start scanning. possible Cause The document is not loaded properly. [. . . ]