User manual PANASONIC KV-SS25D

[. . . ] Do not expose the CD-ROM to direct sunlight or extreme heat and do not scratch or smudge the surface of the CD-ROM. Thank you for purchasing a Panasonic "High Speed Scanner". · For the versatile solution for imaging needs. Panasonic developed Panasonic Image Enhancement Technology to improve the quality of your originals. · Red and Green lamp setting right from the display panel to select dropout color quite easily. · With these easy-to-use functions, reliable paper handling, easy maintenance and more, Panasonic would like to contribute to your imaging needs. · Difference between the KV-SS25D and KV-S2065W is only scanning document size. Please refer to page 47 "Specifications" for details. System Requirements When using the scanner, the required host computer conditions are as follows. [. . . ] Pressing the 2 key once will decrease the user counter extender by one. 02 Clear the user counter Coun t e r Clear 02. User When pressing the 1 key and the 2 key simultaneously, the user counter will be cleared. Then "Completed" will be displayed. Displays the total amount of scanned documents up to now. 03 Displaying the system counter Coun t . Sy s t em (ex. ) 24 Display Panel Instructions Imprinter setting menu (by pressing the IMPRINT key) Both a pre-imprinter and post-imprinter can be installed at the same time. However, the operator may only use one imprinter at a time. If both of the imprinters are installed, you can set the following conditions. Number, item and default display next mode. Contents · Pressing the 3 key will change to the · Pressing the 1 key or the 2 key will change to another value. · Pressing the 4 key will change to the previous mode. 01 Setting the pre-imprinter data Host 01. Pre Imp r i n t Hos t Count Printing will be done according to the host computer. 01 Checking the version MX. XX : FX. XX : Displays the mechanical control firmware version. Displays the pre-imprinter firmware version. If a pre-imprinter unit is not installed, the entry will remain blank. Displays the post-imprinter firmware version. If a post-imprinter unit is not installed, the entry will remain blank. Displays the size of an optional memory. If an optional memory is not installed, this will not be displayed. OFF 01 . Ver s i on BX. XX : XXXM: 02 Setting the buzzer ON ON 02 . Buzzer 03 Setting the SCSI ID ID No . SCS I 0 1 2 3 4 5 6 7 · Setting the SCSI ID will be activated after turning the power off and turning it on again. 04 Setting the terminator Enable Disable 04. Terminator Enab l e When the scanner is located to terminal position on SCSI bus, set to "Enable". · Setting the terminator will be activated after turning the power off and turning it on again. · The internal terminator works only when the unit's power has been turned on. If the PC is to be used while the unit's power is off, be absolutely sure to install an external terminator which is available on the market. [. . . ] (See page 35. ) Open the front door and remove the jammed paper. (See page 35. ) Open the front door and remove the jammed paper. (See page 35. ) Open the front door and remove the jammed paper. (See page 35. ) Open the front door and remove all of the remaining documents. [. . . ]