User manual PANASONIC KX-TG2248S

[. . . ] 2. 4GHz Digital Cordless Answering System Preparation Operating Instructions Model No. KX-TG2248S Pulse-or-tone dialing capability Cordless Telephone Answering System Useful Information Caller ID Compatible PLEASE READ BEFORE USE AND SAVE. Charge the battery for about 6 hours before initial use. Panasonic World Wide Web address: http://www. panasonic. com for customers in the USA or Puerto Rico Thank you for purchasing your new Panasonic cordless telephone. Please read IMPORTANT SAFETY INSTRUCTIONS on pages 58-59 before use. Read and understand all instructions. Caller ID and Call Waiting Service, where available, are telephone company services. After subscribing to Caller ID, this phone will display a caller's name and phone number, then announce the displayed caller's name. [. . . ] The unit will announce the remaining recording time if it is less than 3 minutes. · When you have no new messages, the unit announces "No new messages. All message playback" and plays back all messages. · When you have no messages, the unit announces "No messages". 40 Listening to Messages Using the Handset (Remote Operation) To play back messages 1 Press [MENU]. 2 Scroll to "Message play" by pressing [ ] or > [ ], then press Select. Handset > Message play 4:New messages 5:All messages Repeat Skip · The unit announces the number of new messages and only new messages are played back. · The messages will be heard from the speaker. To switch back to the speaker, press [ ]. · [MESSAGE/SLOW TALK], [REPEAT], [SKIP] and [STOP]* can also be used during playback (p. · When you have no new messages, the unit announces "No new messages. All message playback" and plays back all messages. · When you have no messages, the unit announces "No messages". · If you do not press any buttons, the voice menu will start (see below). 3 To end remote operation, press [OFF] or place the handset on the base unit. *If you press [STOP] on the base unit during message playback, operation is stopped. To resume the playback, press [MESSAGE/SLOW TALK] on the base unit within 15 seconds, or the voice menu will start (see below). · If noise interferes with the message playback: -- during playback using [ ], press [ ] (Channel). -- during playback using [ ], press [ ] (Channel). · At the end of the last message, "End of final message" is heard. The unit will announce the remaining recording time if it is less than 3 minutes. · If the unit starts to ring during the remote operation, press [ ] or [ ] to answer the call. To playback, start again from the beginning after hanging up. · If you hear "Memory full" after playback, erase unnecessary messages (p. 43). > Exit Select > Answering System Voice menu If you do not press any buttons at the end of the last message, the unit will announce "End of final message" and the voice menu will begin. The unit announces, "Press 4 to play back new messages. [. . . ] THE WARRANTOR IS NOT LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT, OR ARISING OUT OF ANY BREACH OF THIS WARRANTY. (As examples, this excludes damages for lost time, lost calls or messages, cost of having someone remove or re-install an installed unit if applicable, travel to and from the servicer. The items listed are not exclusive, but are for illustration only. ) ALL EXPRESS AND IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF MERCHANTABILITY, ARE LIMITED TO THE PERIOD OF THE LIMITED WARRANTY. Some states do not allow the exclusion or limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the exclusions may not apply to you. [. . . ]